Advertisement
Using a lopper with a Ratchet Mechanism is very simple and it adds power to your hands.
If you are used to using a non ratchet lopper then it may take just a few cuts to get used
to the mechanism. But there is nothing to worry about as this is normal.
1)
Move red button to On and
then open the loppers.
2)
Squeeze handles fully together
to start cutting the branch. When
the handles are fully closed, Open
them again until you hear the
Ratchet mechanism click. Then
stop opening them
1)
Open and close handles (as if you were cutting something) until blade is closed.
2)
This allows the ratchet mechanism to engage and keep the loppers closed
3)
Put the plastic cover over the blades
4)
Store in a dry, safe place
Pro Switch 1 in 1 Ratchet Anvil Loppers
User & Care Instructions
Using In 'Ratchet' mode - Max 60mm Cut
Ratchet Mode Closing Instructions
3)
Now the 1st stage of the ratchet
mechanism is engaged.
4)
You can now close the handles, fully again
and cut.
5)
Continue repeating stage 2 and 3 until the
branch is fully cut
Page 5
Advertisement
