Advertisement
Quick Links
Thank you for purchasing a Micro Warlock from TBRC Wings.
Kit Contents
1x Center wing panel
2x Outer wing panels
2x Tail booms
1x Fuselage
1x Coroplast horizontal stabilizer with built in elevator
2x Vertical stabilizers
3x 2mm fiberglass spars
2x Balsa ailerons
3x Plastic control horns for elevator and ailerons
1x 1.5 meters 3mil laminate
1x Decal set
Center of Gravity (CG) is 11mm from the leading edge of the wing.
Advertisement
Related Manuals for TBRC Micro Warlock
Summary of Contents for TBRC Micro Warlock
- Page 1 Thank you for purchasing a Micro Warlock from TBRC Wings. Kit Contents 1x Center wing panel 2x Outer wing panels 2x Tail booms 1x Fuselage 1x Coroplast horizontal stabilizer with built in elevator 2x Vertical stabilizers 3x 2mm fiberglass spars...
- Page 2 Step1 Trim 2mm off the trailing edge of the wing center section. This is so that it fits perfectly inside the booms. Step2 Trim 25mm, the width of the ailerons, off the trailing edge of each outer wing panel. Glue the outer wing panels to the center wing section.
- Page 3 Step3 While the glue is drying on the wing panels cut spar channels into your fuselage and booms and install the fiberglass spars. Fuselage Sparing bottom and sides. For the bottom spar cut to 180mm. This will be installed in Step 11. For the sides they are to be cut at 80mm lengths and can be installed now.
- Page 4 Boom Spars Cut the boom spars to 100mm lengths and install them on the top and sides of the booms as shown. 100mm...
- Page 5 Step4 Cut and add the spars to your wing on top and bottom placed over each other. Be careful, make sure the wing is straight and true without any warps as the glue dries. Pay particular attention to the outer wing panels as not to twist them when weighting them in place.
- Page 6 Step5 Laminate the wing with the supplied laminate. Cut out spaces in the laminate where the booms and fuselage will attach. This allows foam to foam contact for the best bond possible. Step6 Laminate and install the ailerons to the outer portions of the wings. Install the aileron servos next.
- Page 7 Step7 Glue the booms and the fuselage to the wing, be sure that they are straight and parallel. Step8 Glue in the horizontal stabilizer in the slot at the back of the booms. Be sure the elevator is oriented properly at the back of the aircraft.
- Page 8 Glue the vertical stabilizers on the outside rear portion of the booms. Step10 If you are making the Micro Warlock in a pusher configuration you can fabricate a light plywood motor mount plate and attach to the rear of the fuselage as shown.
- Page 9 Step11 Cut the bay plug to the desired height and glue it in place. Install the spar on the bottom. As shown in diagram 3. Step12 Laminate the fuselage and the booms Step13 Install the electronics. The elevator needs only small throws. Connect the pushrod to the center hole and the second hole down on the elevator control horn to decrease pitch sensitivity.