Display Units - Scan-Electronics RadiaCode-101 User Manual

Standalone usage
20
The structure of the

Display units

Measurement units
Dose rate
Dose
Screen
Signals
Bluetooth
Language
Time
Device info
Factory settings
To return to the top level or quit the menu (while in the
3.8.1 Display units
Use [Display units] item of
mode - dose rate or count rate:
Display units depend on
rate selection.
If required, go to next items of
"Settings" submenu with its brief description is shown below:
Selection of the assessment type of radiation intensity for
rate or count rate. This type affects the display units which also depend on
Measurement units: Sv/h or R/h for dose rate selection, CPS (counts/s) or CPM
(counts/min) for count rate selection.
Selection of measurement units:
for dose (dose rate): Sv (Sv/h) or R (R/h);
for count rate: CPS or CPM.
Setting thresholds 1 and 2 for dose rate alarms.
Setting thresholds 1 and 2 for dose alarms; accumulated dose resetting.
Selection of display backlight and rotation modes.
Global: turning on/off the sound and vibration signaling;
gamma quanta registration: turning on/off the sound (clicks) and light signaling;
alarms and buttons: separate turning on/off the sound and vibration signaling.
Bluetooth turning on/off.
Language selection: English, Russian.
Setting current time.
View the information about the device: serial number, firmware version and
bootloader version.
Calling up the menu for reset device settings.
·
set focus on the [<Back] or [<< Menu quit] item
according to your choice;
·
confirm your choice by short pressing the round
button.
Settings to select the presentation type of measurement results for
·
while in the Settings, set focus on the [Display
units] by short pressing the swing buttons;
·
select the presentation type by short pressing
the round button.
Measurement units: Sv/h or R/h for dose rate selection, CPS or CPM for count
Settings by short pressing the "up" and "down" swing buttons.
"Settings" ):
© 2021 Scan Electronics Ltd.
Monitor mode: dose
Monitor