Contols And Indication - Scan-Electronics RadiaCode-101 User Manual

Standalone usage
10
·
install RadiaCode on your computer and run it;
·
connect the device directly to your computer's USB port using the USB cable type-C (supplied with the
device);
·
turn on the device;
·
if there is a fresh version of the firmware, you will be prompted to update it;
·
wait for the update process to finish.
Attention! Do not disconnect the device from the computer while the firmware is being updated.
An attempt to disrupt the download process may lead to a malfunction of the device, which can
only be rectified by a service center.
3.4

Contols and indication

RadiaCode-101 is equipped with a combined user interface:
·
display;
·
buttons;
·
sound emitter;
·
LEDs;
·
vibration signaling.
Sound, light and vibration signaling complement the information presented on the display and provide
feedback when pressing the buttons (see the table below):
Event / state
Turning on
Turning off
USB connection
established
Bluetooth connection
established
Bluetooth connection lost
Low battery
Charging
Finding the device
Button pressed
Quantum fixation
Alarm 1
Alarm 2
Going off the scale
Display status
Sound
bar
tone-rhythm
tone-rhythm
tone-rhythm
tone-rhythm
tone-rhythm
tone-rhythm
tone-rhythm
tone-rhythm
tone-rhythm
Vibration
rhythm
beep whizz
click
rhythm
rhythm
rhythm
Light
blue, continuous
green / red,
flashing
display backlight
display backlight
display backlight
© 2021 Scan Electronics Ltd.