Advertisement
Quick Links
Installation instruction data display
VW Golf MK7
Preface
Thank you for purchasing the MFD32 for your VW Golf MK7.
During the development of the product, we paid high attention to accuracy and quality.
With these installation instructions, the display was trial-assembled by several test
persons and continuously improved, so that you do not have any problems during the
installation.
If you have any feedback, criticism or change requests, please send us an email to
info@canchecked.de.
Version v0.1
www.canchecked.de
Advertisement
Related Manuals for CAN CHECKED MFD32
Summary of Contents for CAN CHECKED MFD32
- Page 1 VW Golf MK7 Preface Thank you for purchasing the MFD32 for your VW Golf MK7. During the development of the product, we paid high attention to accuracy and quality. With these installation instructions, the display was trial-assembled by several test persons and continuously improved, so that you do not have any problems during the installation.
-
Page 2: General Information
General information The display unit is a very sensitive device. One should act with extreme caution and avoid any pressure on the housing or the display itself. CANchecked assumes no liability for this conversion or for damage during the conversion or operation. The instructions were created to the best of our knowledge and belief. - Page 3 1) Dismantling the radio cover Use the assembly tool to carefully pry off the cover at the corners. The left area of the high-gloss cover to the speedometer is also clipped and must be levered off. Version v0.1 www.canchecked.de...
- Page 4 2) Removel air duct The ventilation duct can now be pulled out together with the cover. Please unplug the two plugs and pull the ventilation duct including the cover towards you. Version v0.1 www.canchecked.de...
- Page 5 3) Disassembling of the ventilation duct The front panel is held in place with small clips. Carefully pry it off with a small flat screwdriver. Gradually, the cover will come off. The hazard warning switch is pulled out forwards: Version v0.1 www.canchecked.de...
- Page 6 4) Dismantling the ventilation grille The ventilation grid is held in place with noses on both sides. Press the tabs inwards and slightly bend the frame of the grille so that the grille can be removed from the front. For the vertical sticks, widen the frame up and down a little and then remove it as well.
- Page 7 5) Remove the lower dashboard panel First, pry off the left cover to the fuses. Remove the torx screw. Now unscrew and remove the lower cover at the shown 4 points: Version v0.1 www.canchecked.de...
- Page 8 6) Lay the cables The connection cable is now pulled from the direction of the OBD connector above to the display. A stronger wire (like welding wire) may help, which you push down from the direction of the ventilation grille, attach the cable to the wire and then pull it carefully up.
- Page 9 Please URGENTLY check the assignment of the cable. With the OBD cable, there is a slip of paper with the assignment. Red => A5 (12V) Black => A1 (ground) Yellow => B3 (Can Low) Green => B2 (Can High) The connection should be checked before assembly. In this case, it is sufficient to switch on the ignition when all plugs from both the display and other components are connected in order to avoid error entries.
-
Page 10: First Start-Up
7) Assembly The assembly is done in reverse order. The display should only be plugged into the OBD socket when all the plugs on the radio and buttons are plugged in again. 8) First Start-up Once everything is back in place, the display can be plugged into the OBD socket. - Page 11 choose the one that suits you. Tap on "Sensor" again, so the standard widget bar appears. If you tap on “Position”, “Size” and four arrows appear to adjust the size of the widget. When you are finished with all settings, press "done". With "Exit"...