Turning Off The Projector - InFocus LP725 User Manual

S e t t i n g
NOTE: With some computers,
the order in which you power up
the equipment is very important.
Most computers should be turned
on last, after all other peripherals
have been turned on. Refer to your
computer's documentation to
determine the correct order.
CAUTION: When you
disconnect the projector after you
have switched it off, always
remove the power cord from the
electrical outlet first, then remove
it from the projector.
22
u p t h e
If you don't want to hear the sound from your video player,
•
press the
5 If you connected any external speakers, turn them on.
6 If you connected your monitor, turn it on.
7 Turn on your computer.
The computer image should display on the projection
•
screen. (If a video source is active, press the
ton to display your computer's image.)
If necessary, use the
•
adjust the brightness. You can make further adjustments to
the image from the projector's on-screen menus. To open
the menus, press the
select the Display menu or the Image menu. For more infor-
mation about the menus, see page 29.
If you don't want to hear the sound from your computer or
•
video player, press the

Turning Off the Projector

If you want to turn off the projector for a short period of time,
press the
standby
15 minutes, but keeps the projector running. After 15 minutes, the
lamp goes out (the projector keeps running). To exit standby
mode, press the
the projection lamp to reach full power and project the image
again.) You can change the amount of time the projector stays in
standby mode; see "Standby TIme" on page 37 for details.
To completely power off the projector, press the "O" side of the
power switch on the front of the projector. If you want to turn the
projector back on immediately, you must allow about 30 seconds
for the lamp to cool. The lamp won't light if it's too hot.
P r o j e c
button.
mute
brightness
button on the keypad. Then
menu
button.
mute
button on the keypad. This blanks the screen for
button again. (It takes several seconds for
standby
t o r
computer
buttons on the keypad to
but-