SETTING UP THE PROJECTOR
1 Place the projector on a flat surface.
The projector must be within 10 feet (3 m) of your power
•
source and within 10 feet of your computer.
If you want to project from behind a translucent screen, set
•
up the projector behind your screen. See "Rear Projection"
on page 38 to reverse the image.
If you are installing the projector on the ceiling, refer to the
•
LitePro 700 Series Ceiling Mount Installation Guide that comes
with the Ceiling Mount Kit for more information. To turn
the image upside down, see "Ceiling" on page 38. The Ceil-
ing Mount Kit is sold separately; see page 54.
2 Position the projector the desired distance from the screen.
The distance from the lens of the projector to the screen
•
determines the size of the projected image. Figure 4 shows
three projected image sizes using the lens at minimum
focusing distance. For more information about image size,
see "Projected Image Size" on page 60.
3 Make sure the projector and your computer are turned off.
6.5 ft.
3.3 ft.
Projected image size (minimum focusing distance)
32.5 ft.
F
4
IGURE
NOTE: An optional extension
cable, sold separately, lets you
increase the distance between the
projector and your computer to
70 feet (21 m). See "Accessories"
on page 53.
7