Advertisement
Quick Links
850-WSP
OPERATION, MAINTENANCE
AND INSTALLATION MANUAL
Part Number 850-WSP (15') (4.572 M) Model 7009
CAUTION:
Disconnect power before servicing. Read instructions thoroughly.
Check local codes and install to meet requirements
SPECIFICATIONS
MECHANICAL
DESCRIPTION OF OPERATION & MAINTENANCE
The Water Sensor probe is a reliable water detection sensor that can be used in a wide variety of applications
such as: sumps, water tanks and drain pans.
The solid state circuitry is encapsulated in epoxy making the unit waterproof and tamperproof. The probes are stainless steel and
will not rust. Works excellent even with distilled and condensate water.
When connected to the ALARM PANEL and when water bridges the probes, the ALARM PANEL activates the
buzzer and flashing alarm light. Auxiliary contacts can be utilized to annunciate the alarm or wired into a
control circuit that will shut the machine off to prevent further water leakage. Connect as many Water Sensors
or floats to the ALARM PANEL as needed for zone area protection.
Water Sensor Probe
ELECTRICAL
Voltage: 9-12VDC
Operating Current: 3 ma
Switching Current: 500 ma Maximum
MODEL NUMBER NOMENCLATURE
Standard Part number 7009 (MODEL NUMBER 850-WSP) - comes
with 15' (4.572 M) of cable. For extra cord length please contact
Boshart.
BOSHART.COM
Advertisement
Summary of Contents for BOSHART 850-WSP
- Page 1 Voltage: 9-12VDC Operating Current: 3 ma Switching Current: 500 ma Maximum MODEL NUMBER NOMENCLATURE Standard Part number 7009 (MODEL NUMBER 850-WSP) - comes with 15’ (4.572 M) of cable. For extra cord length please contact Boshart. DESCRIPTION OF OPERATION & MAINTENANCE The Water Sensor probe is a reliable water detection sensor that can be used in a wide variety of applications such as: sumps, water tanks and drain pans.
- Page 2 850-WSP Water Sensor Probe OPERATION, MAINTENANCE AND INSTALLATION MANUAL DESCRIPTION OF OPERATION & MAINTENANCE CONTINUED Disconnect Power. Determine location for water detection. See Figure 1 Install the ALARM PANEL per Installation Instruction for the ALARM PANEL. Secure the sensor to the discharge pipe at the desired alarm level (the alarm level will be when the liquid touches the metal at the bottom of the probes).