BubbleWall 200FS Assembly Instructions

Bubble Wall 200FS - Assembly Instructions
:
Supplies Required

1 gallon of distilled water - We recommend to pick up an additional gallon for top offs. Distilled water
can be purchased at all grocery and pharmacy stores. *Note: Tap water has chemicals that will stain and
damage your tank, never use this in your bubble wall!
Safety:

Do not make any wiring connections, including extension cords, inside the base unit of your bubble wall

We recommend all bubble walls and fountains be plugged into Ground Fault Circuit Interrupter (GFCI)
outlets for added safety
Included in the box

Bubble Panel Tank with LED Lighting Controller Attached

Base Stand & Cover

LED Lighting Power Supply Plug

Air Pump & Tubing
Bubble Tank Assembly

Remove the bubble tank and base stand from the box, as well as all packaging and check for any damage.
Note: Condensation may be present in the tank, as they are tested full of water prior to shipment

Important – When installing the bubble tank into the stand, keep the white LED controller box on the
front of the bubble tank on the same side as the cut-out in the bottom of the base stand as shown in
Figure 1 below

Slide the bubble tank panel down into the base stand until it is fully seated. (Figure 1) Note the position of
the lighting strip wire, and air tube exiting the bottom of your tank, and take care when sliding the bubble
tank down as to not pinch or kink these connections in the base stand
Figure 1
Continued on page 2
Page | 1