Advertisement
AVALON INSTRUMENTS MOUNTS
The following fundamental 4 steps, must be set at least one time
We strongly suggest to read carefully the StarGo User Manual and the Mount User Manual
Step 1
Power On the StarGo
1 & 2 - Connect the StarGO to the PC by using the provided USB cable
3 - Connect the provided power supply to the the home power outlet
4 - Check that the power supply output it is set on 15v
5 - Connect the power supply to the StarGo board
Step 2
Install the StarGo Software on the Pc
1 - Insert the provided USB Pendrive in the PC USB port
2 - Install the Installer_StarGO_XXX.exe
that comes with the provided pendrive
(The installer le it is located inside
the Installer-Tutorial-Software Folder)
NOTE: The installer must be
NOTE: Always check on our o cial
Support Web Page for updated versions
Step 3
Launch the StarGo Software
1 - Double click on the StarGo.exe software icon
2 - Click on the gear button
3 - Select the connection mode (USB, Bluetooth or Wi-Fi)
NOTE: to establish a wireless connection the device
must be rst paired with the StarGo board. See StarGo
User Manual from page 47 to page 52
4 - Normally the mount comes already con gured from
the factory, check in the ADVANCED panel
5 - In case the mount doesn't match, select the correct
Mount Con guration File in the SYSTEM panel and press
on the Load button
Step 4
Set your Observatory Location
Click on the ALIGN panel and set your
OBSERVATORY LOCATION coordinates.
NOTE: in order to have the correct mount
behaviour, any other software (planetary,
sequencer etc.) must have the same coordinates
system
QUICK START GUIDE
and it is required only during the rst mount setting
"Run as administrator"
5
4
1
2
1
4
1
2
3
2
3
5
Advertisement
Table of Contents
Related Manuals for Avalon Instruments M-Zero AV-1MZR007
Summary of Contents for Avalon Instruments M-Zero AV-1MZR007
- Page 1 AVALON INSTRUMENTS MOUNTS QUICK START GUIDE The following fundamental 4 steps, must be set at least one time and it is required only during the rst mount setting We strongly suggest to read carefully the StarGo User Manual and the Mount User Manual...
- Page 2 Since the mount alignment procedure (Sync Home Position) is not available on SkySafary and on other planetary app, Avalon Instruments developed a solution to solve this missing important function. Simply perform the following steps. 7b - Choose a star close to the Southern Meridian and to the Horizon, then perform a Sync on it, without move the mount from his Celestial Pole pointing.
Need help?
Do you have a question about the M-Zero AV-1MZR007 and is the answer not in the manual?
Questions and answers