LMSM19042401 Notice Contents 1. This is a universal”and semi-universal child restraint,it is approved to “ “ ” Regulation NO.44,04 series of amendments,for general use in vehicles and 1.Vital information-READ NOW..............3-4 it will fit most,but not all,car seats. 2. Safety instruction..................5 2.
1. Vital information-READ NOW To prevent from the risk of fall,your child should always be fastened. For your child’s safety,please read these instructions carefully before use and keep them for future reference.Failure to follow the instructions contained in this manual It is dangerous to make any alteration or additions to the device without the could result in serious injury to your child.
2. Safety instruction 4. Parts and interior equipment Only suitable if the approved vehicles are fitted with 3 point safety-belts,approved to UN/ECE DIAGONAL BELT DIAGONAL BELT Regulation No.16 or other equivalent standards. Headrest LAP BELT LAP BELT Height adjuster Backrest NOTICE:If the buckle strap of car seat is too Manual bag long, the child restraint system can not be...
5. Assembling the seat 6. Installation of the seat Suitable for the child from 15 to 36kgs(4-12years) 6.1 3-point car seat belt installation Step 1:Align base and backrest in a straight line. Step1: Press the button on the bottom and turn isofit connector to hide.
Page 6
Step 3:Follow the B4 routine to install the baby car seat. Too high Right Too low Step 6:Fasten car seat belt and make sure, it is tight enough. Step 4: Put the child in the seat and follow B4 routine. Notice: If car seat belt is too long, it is not suitable to tighten...
6.2 Isofit installation Step 1:Turn the seat to the bottom Step 3:Find out isofix connections in the car. and pull out isofit connector.(C1、 C2) Step 4: Insert isofix guide into isofix connection Step 5: Push child seat follow the direction and insert isofit connector Step 2:Turn isofit connector to 180 into isofix guide.
Page 8
Step 6: Check if isofit locking system Step 9: Adjust the height of headrest turns to green and make sure child and belt slot to suitable height of seat is firmly connected. child(C10、 Step 7: Put the child into the safety car seat.
Step 2:Push backrest to make it Step 11: Pull child seat forward and slide separate from booster the locking system. When you hear “click” and it turns to red, isofit connector is released. Step 3:Take off the elastic of fabric Step 12: Take child seat away from car seat.
Step 5: Take off the fabric cover. ※ Follow in reverse order and repeat the procedure to put on the fabric cover 8. Maintenance and cleaning 8.1 Daily maintenance 1. In daily use,check periodically the child seat.The child seat should be replaced after an accident.