Operation Guide - FalconEye Electronics 1440P 2nd Gen User Manual

4. Parking Monitor
When you park your car, enable parking monitor function to capture and save incidents
that occur while away.
automatically begin recording.
NOTE: The inside battery is meant to only power on around 2~3 minutes when not
charging. Parking Monitor function can only be used
power source.

Operation Guide

1. Power On/Off: Long press power button around 2~3 seconds to turn on & off. If have
SD card inside, once turn on it will enter into recording mode automatically.
2. Start/Stop recording: In video mode, short press OK button start recording, short press
it again, the recording will be stopped.
3. Photo : In photo mode, short press OK button can take photo
4. Playback: In playback mode, short press OK button can play the video.
5. OK button: In video mode/photo mode/playback mode, short press menu button enter
into menu, short press up/down to browse, short press OK
button to confirm.
6. Up button: Function arrow up button in menu options. In standby mode, Function to
switch modes. Hold to set motion detection on/off. In playback mode,
video recordings.
7. Down button: Function arrow button down in menu options, shortcut hold button of
turning on / off the recording sound. In playback mode, press to fast forward video
recordings.
While powered ON, the camera will sense motion and
when connected to a constant
4
press to rewind