ULSee HC100 Quick Installation Manual

ULSee Health Watch
Quick Installation Guide For HC100
1. Health Watch Basics Features
Function Key
Wristatrap
Diplay Screen
| Charging Method
For the first time, please take the Health Watch out and charge the equipment with the
corresponding charger. When charging, Health Watch will open automatically.
(Charge mode: Joint the USB-charging cable with Band at match point backsideand USB
port for charging. Charge voltage 5V)
| Wearing Method
1. Best wear the Heath Watch behind malleolus ulnaris;
2. Adjust the size suitable for the size of wrists via Adjustment Hole, fasten wrist strap
buttons;
3. Sensor shall be close to skin avoiding moving.
Malleolus Ulnaris
Left Hand
Ensor
| Power On/ Off
1. Power On: In the state of the shutdown, long press function key
over 3 seconds can make the device vibrate and boot.
2. Power Off: When the Health Watch is On, short press function
key few times to setting interface, then long press function key
enter setting mode. In this mode, short press function key few
times to the shutdown interface, then long press function key over
3 seconds to shutdown.
2. Install Three Apps
Scan the following QR code to download the apps:
Join Health app, Google fit app, Alexa app.
JOIN HEALTH android app
JOIN HEALTH ios app
Adjustment Hole
3. Device Connection
Connect Health Watch to Join Health app for the first-time setup.
Health Watch will synchronize time with phone app automatically during initial setup,
so step counts, heart rates, and temperature data are updated correctly afterward
Bluetooth connection: After first successful connection, JOIN HEALTH app will
automatically search and connect with Health Watch whenever the app is turn on.
4. JOIN HEALTH App Set up
4.1 Welcome page
shutdown interface
Google fit android app Alexa android app
Google fit ios app Alexa ios app
4.2 Create an Account: 4.4 Scanned
4.3 Main Page:
- Look for Verification Email in My Devices
Your Inbox
- Verify Your Account to Sign
In for the First Time
5. Google Fit Binding
5.2. Home Page
5.4. Sign In with Google account
5.4.2 Then Click "Go to ulsee.club"
5.6. Add & See Your Physical Info
to Your Data
5.8. Allow Permissions
Devices
5.1. https://iot.ulsee.club/homebutler/sign-in
Sign In with JOIN HEALTH App Account
5.3. Click on Google Fit Button
in Account Binding Section
5.4.1 If there shows a warning window,
please click "Advanced" below
5.5. Add & See Your Heart Rate Info
to Your Data
5.7. Confirm Your Choices
5.9. Account Is Connected