Like It The Container Store Assembly Instructions

3
-Section
Shoe / Accessory
Grid
Assembly Instructions

Step-1

When assembling a base, insert the connectors into the main board and two side boards.
The ridged side should be facing upward.
Ridged side
Main board

Step-2

Repeat Step-1 to complete the 3-Section Shoe / Accessory Grid.
Note: If using this product for Boot Storage, skip to the next page.
※
Base

Step-3A - If using partitions as back panels.

Flip the grid over and
①
insert 2 connectors
as shown below.
Supply units Supply units
Main board × 4
The ridged side should
be facing upward.
Connector
Side board
Ridged side
Place the partition into
②
the slot of the main board
as the back panel.
Partition
Side board × 6
Base
to finish inserting
Repeat
③ ②
the remaining 2 back panels.
Partition × 3 Connector × 16
For Boot Storage:
Follow the instructions on the back.
Boot
2 cubbies
By excluding the main board
in the middle, the 2 cubbies
become Boot Storage.
Insert the remaining
④
6 connectors.
Insert the partition
to the end.