Advertisement
6
-Section
Shoe / Accessory
Grid
Assembly Instructions
Step-1
When assembling a base, insert the connectors into the two main boards and three side boards.
The ridged side should be facing upward.
Ridged side
Main board
Step-2
Repeat Step-1 to complete the 6-Section Shoe / Accessory Grid.
Note: If using this product for Boot Storage, skip to the next page.
Base
Step-3A - If using partitions as back panels.
①
Flip the grid over and
insert 3 connectors
as shown below.
Supply units
Main board × 8
The ridged side should
be facing upward.
Connector
Side board
Ridged side
②
Place the partition into
the slot of the main board
as the back panel.
Partition
Side board × 9
Base
③
Repeat
②
to finish inserting
the remaining 5 back panels.
Partition × 6
Connector × 24
Follow the instructions on the back.
Boot
2 cubbies
By excluding the main board
in the middle, the 2 cubbies
become Boot Storage.
④
Insert the remaining
9 connectors.
Insert the partition
to the end.
Advertisement
Table of Contents
Related Manuals for Like It The Container Store 6-Section Shoe / Accessory Grid
Summary of Contents for Like It The Container Store 6-Section Shoe / Accessory Grid
- Page 1 -Section Supply units Shoe / Accessory Grid Assembly Instructions Main board × 8 Side board × 9 Partition × 6 Connector × 24 The ridged side should be facing upward. Step-1 When assembling a base, insert the connectors into the two main boards and three side boards. The ridged side should be facing upward.
- Page 2 Step-3B – If using partitions on interior of grid. Place the partition into the 2 holes in the middle of the main board. For easy assembly, position the partition at an angle then turn it upright. Partition For Boot Storage ①...
Need help?
Do you have a question about the The Container Store 6-Section Shoe / Accessory Grid and is the answer not in the manual?
Questions and answers