A. Software setting
Before the operation, you should install the Laser USB driver, connect
the Power Adapter and the Interlock and make sure the USB cable
communicated well.
a) Open the software as follow;
b) You could see the operational window.
B. Switch on the Laser
a) Take off the protection cap of output fiber;
b) Click the "Laser On",
Input Power from 0% →30%→50% →80%→100%
c)
E-mail:sales@yslphotonics.com
Tel:027-87204039
Replied "
Laser on
- 5 -
";