Page 1
HOST MACHINE CAT 320 NG CAT 320 NG Reach boom 489-2981 Stick 2,9 mt 356-8117 Installation manual Division: Tecnoter srl Hp one way, one ILAE / ILA CAT 320NG Page 1/15 Rev: 1.1_En – pump. Basic ver. Reach – 2,9 mt...
Page 2
Before using this manual, please access SIS and print the following documents: Electric schematic Hydraulic schematic 552-5468 564-5033 490-2711 551-6783 356-8117 489-2981 Division: Tecnoter srl Hp one way, one ILAE / ILA CAT 320NG Page 2/15 Rev: 1.1_En – pump. Basic ver. Reach – 2,9 mt 19/07/2019...
Manufacturer identification......................7 INSTALLATION PROCEDURE......................8 Line Gp stick – line Gp boom......................9 Line Gp front and pump.........................11 Electronic set-up..........................16 Testing and adjusting........................17 Division: Tecnoter srl Hp one way, one ILAE / ILA CAT 320NG Page 3/15 Rev: 1.1_En – pump. Basic ver.
If the manufacturer made any change in this manual, the customer must verify that only updated versions of it would be present in site where the machine is used. Division: Tecnoter srl Hp one way, one ILAE / ILA...
Par. = Paragraph Pag. = Page Fig. = Figure Tab. = Table UNIT OF MEASURE Units from the International System of Units (SI) Division: Tecnoter srl Hp one way, one ILAE / ILA CAT 320NG Page 5/15 Rev: 1.1_En –...
• have the skill of assembly and operating the specific type of equipment; • have familiarity with the specific regulations of the matter. • Division: Tecnoter srl Hp one way, one ILAE / ILA CAT 320NG Page 6/15 Rev: 1.1_En –...
GENERAL INFORMATION Manufacturer identification Manufacturer Tecnoter srl a socio unico VAT: IT13072070157 Head office P.zza Eleonora Duse 3 20121 Milano Italy Production site Via Carlo Alberto dalla Chiesa 6 20098 San Giuliano Milanese (MI) Italy After sales service / Spare parts...
Double check each hydraulic installation before operate the system. Attention: In case of local laws or restrictions were applicable on the use of this upgrade kit, the operator must strictly observe them. Division: Tecnoter srl Hp one way, one ILAE / ILA CAT 320NG Page 8/15 Rev: 1.1_En –...
5I-8510 to the tube just installed Using the provided clamps, bolts and washers, install the tube 253-6453 with valve 389-2407 on the stick (Rh side), then connect the hose 253-6445 to the tube 253-6453 Division: Tecnoter srl Hp one way, one ILAE / ILA...
Page 10
Connect the hose 216-6589 to the Rh line, rear side Using the provided clamps, bolts and washers, install the Lh line 513-3071 on the Lh side of the boom Connect the hose 288-7502 to the Lh line, rear side Division: Tecnoter srl Hp one way, one ILAE / ILA...
WARNING: harnesses, valve 555-8147 with rods, seals and accessories is not included in the kit Print SIS page 564-5033 Print SIS page 490-2711 551-6783 Division: Tecnoter srl Hp one way, one ILAE / ILA CAT 320NG Page 11/15 Rev: 1.1_En –...
Page 12
Print SIS page 552-5468 WARNING: illustration for reference only. Some parts have been replaced by Tecnoter parts Strictly follow this manual Division: Tecnoter srl Hp one way, one ILAE / ILA CAT 320NG Page 12/15 Rev: 1.1_En – pump. Basic ver.
Page 13
Referring to the following image, install the support 492-2021TEC with the spacers SPBLCK NOTE: in the basic-version-kit, the pressure sensor 344-7392 has not to be electrically connected, even if present. Division: Tecnoter srl Hp one way, one ILAE / ILA...
Page 14
Contamination control rule: be sure to well clean the pipe after drilling and block welding. 11. Fix the hose support SP1.14 where indicated by red arrow to preserve the hose integrity Division: Tecnoter srl Hp one way, one ILAE / ILA...
Solenoid variable relief (E-RV1, E-RV2): not installed Activation: Rh modulation handle (or switch if available and preferred) Please don't hesitate to contact our technical service for any further detail. Thank you for choosing Tecnoter products Tecnoter Group Offices: Piazza Eleonora Duse, 3...
Need help?
Do you have a question about the O Series and is the answer not in the manual?
Questions and answers