Advertisement
Available languages
Available languages
4-WAY INSTALLATION (3+ Dimmers)
!
In locations with 3 or more dimmers, the following rules will be true:
•
2 locations will have 3-way dimmers: 3 wiring terminals plus a ground terminal.
•
All remaining locations will have 4-way dimmers: 4 wiring terminals plus a ground terminal.
3-WAY
1
Ground
1
Follow steps 1 - 3 in the "3-WAY INSTALLATION (2
Dimmers)" section, removing 3- and 4-way dimmers from
the wall in step 3. All dimmer locations must have a neutral.
3
(Make sure circuit breaker is still OFF from previous steps.)
At each 4-way dimmer location, identify the 2 separate
pairs of wires
4-Way Dimmer
1
2
5
Connect HALO Home Accessory
Dimmers at each 4-way dimmer
location using provided wire nuts.
i. Connect 1 pair of wires to the
Accessory Dimmer's black wire.
ii. Connect the bare copper or green
ground wire from the wall-box to the
Accessory Dimmer's green wire.
iii. Connect the other pair of wires to the
Accessory Dimmer's red wire.
iv. Connect the neutral wire in the wall-
box to the Accessory Dimmer's white
wire. (NEUTRAL IS REQUIRED).
6
Using the screws provided (C), mount all dimmers in the
wall-boxes and attach wall plates (not included).
8
Using your smart phone/tablet, follow the online Quick Start Guide to pair this product to your HALO Home account.
support.BringHaloHome.com
2
3
4-WAY
1
3
Ground
2
At the two 3-way dimmer locations, follow steps 4 - 11 in
the "3-WAY INSTALLATION (2 Dimmers)" section and then
return to this section for further instruction.
4
Disconnect the wiring, keeping the 2 pairs separated.
4-Way Dimmer
Pair 1
7
Turn ON power at the circuit breaker. (An LED indicator will
start flashing on all dimmers when power is turned ON).
2
4
1
2
Pair 2
Advertisement
