Halo home Smart MicroEdge HLB QL6 Installation Instructions Manual

ENGLISH
QuickLink Low Voltage Kit Installation Instructions
Smart MicroEdge™ Downlights: HLB QL6 and HLB QL4
PACKAGING CONTENTS
A. Smart MicroEdge Downlight
B. Bluetooth Module
C. QuickLink Connector
ITEMS REQUIRED (Purchase separately)
Safety Glasses
•
Gloves
•
Hole/Drywall Saw
•
Wire Strippers
•
Flathead Screwdriver
•
*Refer to the online Quick Start Guide for claiming and setup: support.BringHaloHome.com/SmartLight
When using product, basic precautions should always be followed, including the following:
Heed all warnings, including below warnings AND those included on product.
•
HALO™ recessed luminaires (fixtures) are designed to meet the latest NEC requirements and are certified in full compliance with UL. Before attempting installation of
•
any recessed lighting luminaire check your local electrical code. This code sets the wiring standards for your locality and should be carefully studied before starting.
Read and follow these instructions.
•
Do not make or alter any open holes in an enclosure of wiring or electrical components during kit installation.
•
To prevent wiring damage or abrasion, do not expose wiring to edges of sheet metal or other sharp objects.
•
Connect fixture to a 120 volt, 60 Hz power source. Any other connection voids the warranty.
•
Fixture should be installed by persons with experience in household wiring or by a qualified electrician. The electrical system, and the method of electrically connecting
•
the fixture to it, must be in accordance with the National Electrical Code and local building codes.
WARNING - Risk of fire or electric shock. Install this kit only in luminaires that have the construction features and dimensions shown in the photographs and/or drawings
•
and where the input rating of the retrofit kit does not exceed the input rating of the luminaire.
Risk of Fire - MINIMUM
90°C SUPPLY CONDUCTORS. If
uncertain, consult an electrician.
Risk of Electric Shock -
To avoid possible electrical shock,
be sure that power supply is
turned off at fuse box or circuit
breaker before installing or
servicing luminaire.
D. Remote Driver and
IMPORTANT SAFETY INSTRUCTIONS
Risk of Fire/Electric
Shock - LED Retrofit Kit
installation requires knowledge
of luminaires electrical systems.
If not qualified, do not attempt
installation. Contact a qualified
electrician. Luminaire wiring and
electrical parts may be damaged
when drilling for installation
of LED retrofit kit. Check for
enclosed wiring and components.
Junction Box
OPTIONAL ITEMS
Edges may be Sharp -
Wear gloves while handling.
E. Low Voltage Cable
F. Cable Termination Cap
Drill
•
Screws for mounting (if required by
•
local code
New Construction Mounting Frames
•
(4": HL4RSMF; 6": HL6RSMF)