Page 1
Welcome to Immersive Learning with Strivr Get ready Get ready to experience Immersive Learning. You’ll be putting on a VR headset and exploring training activities in a virtual world. This booklet will give you an overview of how to use the equipment and what to expect, plus some troubleshooting tips.
Page 2
Do this by holding down the home button for two seconds. Control the volume with the buttons on the side of the controller, pause the experience with the back button, and exit to the Strivr menu with the home button.
Page 3
The headset includes a detachable inner top strap for a good fit. If you take it off, be sure not to lose it. SIDE STRAP Once the headset’s charged and powered on, you’re ready to start training with Strivr.
Page 4
Select the return arrow to go back to training. In the headset, you can check that you’re connected by visting the About page. Select About on the menu screen and make sure the status reads Connected to Strivr.
Page 5
Log in and train When you put the headset on, you’ll see several screens with the kind of information you’re reading right now: how to adjust the headset and how to use the controller. Next you’ll be asked to log in with the credentials you received from your company. Then you’ll pick a training experience and dive in.
Page 6
Finish up When your training ends, make sure to log off inside the headset—if you don’t, your results can’t be sent to your company and you won’t get credit for the training.
Page 7
Starting from the center of the lens, gently wipe the lens in a circular motion moving outwards. Place the headset and controller back into the tray and plug the charging cable into the headset. Thank you for training with Strivr...
Troubleshooting The screen is black to blink—when the light turns off, the controller is paired. Try the following solutions in order until one • If these solutions don’t work, try replacing works: the controller batteries. NOTE: you can • You may have pressed the power button check the battery level during training on the headset when putting it on.
Page 9
If the About screen in the headset does not Discomfort can happen, especially for first-time say Connected to Strivr, it cannot transfer VR users. If you feel discomfort, the first thing training results and download training content. to do is take off the headset and relax for a few If the About screen says Wi-Fi not enabled, minutes.
Health & safety warnings Strivr health & safety warnings USING VIRTUAL REALITY (“VR”) CAN PO- These conditions may trigger previously unde- TENTIALLY HAVE UNINTENDED HARMFUL tected epileptic symptoms or seizures even in EFFECTS ON YOUR HEALTH OR SAFETY. TO persons who have no history of prior seizures REDUCE THE RISK OF PERSONAL INJURY, or epilepsy.
If you ing—or immediately after using—a VR headset. have a pacemaker or other implanted medical Remove any tripping hazards from the area device, DO NOT USE STRIVR WITHOUT FIRST before using the headset. CONSULTING YOUR DOCTOR OR THE MAN-...
Page 12
Content While using a VR headset, you may need to ex- tend your arms fully out to the side or over your VIEWER DISCRETION ADVISED. CONTENT head, so make sure all of those areas are clear. VIEWED IN THE VR HEADSET MAY CONTAIN Remember that while using a VR headset, VIOLENT IMAGES OR STRONG OR PROFANE other people may enter your immediate area...
Need help?
Do you have a question about the STRIVR and is the answer not in the manual?
Questions and answers