Advertisement
TROUBLE SHOOTING
Before requesting any service on your Iceblue unit, please check the following points.
Service calls resulting from lack of maintenance or misuse is not covered under
warranty and also may void warranty. Please note that this guide serves only as a
reference for solutions to common problems.
SYMPTOM
Compressor not
running.
Condensing unit
runs for long
periods of time.
Cabinet
temperature is too
warm.
Cabinet is noisy
POSSIBLE CAUSE
Fuse blown or circuit breaker
tripped.
Power cord unplugged.
Cabinet in defrost cycle.
Excessive amount of warm
product placed in cabinet.
Prolonged door opening or
door ajar.
Door gasket not sealing
properly.
Dirty condenser coil.
Thermostat set too warm.
Blocking airflow.
Excessive amount of warm
products placed in cabinet.
Fuse blown or circuit breaker
tripped.
Dirty condenser coil.
Prolonged door opening or
door ajar.
Loose part(s)
Tubing vibration.
Water box too close to
piping.
CORRECTIVE ACTION
Replace fuse or reset circuit
Breaker.
Plug in power Cord
Set thermostat to lower
temperature.
Wait for defrost cycle to finish.
Allow adequate time for product
to cool down.
Ensure doors are closed when
not in use. Avoid opening doors
for long periods of time.
Ensure gaskets are snapped in
completely. Remove gasket and
wash with soap and water.
Check condition of gasket and
replace if necessary.
Clean the condenser coil
Unplug unit and allow coil to
defrost. Make sure thermostat is
not set too cold. Ensure that
door gaskets are sealing
properly.
Set thermostat to lower
temperature.
Re-arrange product to allow for
proper airflow. Make sure there
is at least four inches of
clearance from evaporator.
Allow adequate time for product
to cool down.
Replace fuse or reset circuit
breaker.
Clean the condenser coil.
Ensure doors are closed when
not in use. Avoid opening doors
for long periods of time.
Located and tighten loose part.
Ensure tubing is free from
contact with other tubing or
components.
Advertisement
