RATH MICROTECH SMARTPHONE II Simplified Programming Instructions

R A T H M I C R O T E C H
Technology of the future, available today!
SIMPLIFIED PROGRAMMING INSTRUCTIONS

To begin programming

1. Plug line cord into standard telephone line.
2. Connect transformer to 110V AC.
3. Press START

To program CALL TRACKER

1. Press START.
Will get deedoodee tone. Message maximum length is 18 seconds.
2. Press PAUSE
get deedoodee tone when done.
NOTE: If you want to disable
Will get deedoodee tone. No
during the phone operation

To Program numbers

1. Program first number by pressing
be dialed and then
Will get deedoodee tone.
2. Program the second number by pressing
to be dialed and then
Will get deedoodee tone.
3. If you wish to disable automatic dialing of second number, press
SET followed by

To program the timer

1. Press SET followed by
Then press SET

To end programming

1. Hold STOP until warble sounds, then release. If you get three
low beeps, the
Press and hold again until the warble sound.
2. CALL TRACKER,
reprogrammed at any time.
TELEPHONE
PHONE LINE
CONNECTOR
D14
GREEN
LED
POT
SMARTPHONE II
and release. Will get deedoodee tone.
Speak message. Press
key to play back the
CALL TRACKER,
CALL TRACKER
M1 to store the number.
M2 to store the number.
M2.
SET again and the time (1-999 miinutes).
to store the time-out. Will get deedoodee tone.
STOP key was not held long enough.
telephone numbers and timer can be independently
A/C TRANSFORMER
TO
LINE
TO
110V
AC
SOURCE
NOTE:
J2
SMARTPHONE II can
6 POSITION
TERMINAL BLOCK
be programmed
without connection
RATH MICROTECH
to 110V AC or the
1 2 3
SET
6
4 5
START telephone line when
7 8
9
STOP
back-up battery is
0
M1 M2
PAUSE
SUSSEX, WI fully charged.
STOP at end of message.
CALL TRACKER
press
message will play
SET followed by the number to
SET followed by the number
FAX 12
message. Will
START then STOP.