Pavlok 3 Quick Start Manual

Download this manual

Pavlok 3 Quick Start Guide

All buttons can be re-programmed to perform various other actions

Charging

When you first receive the device, we recommend you connect the provided USB-C

cable to the Pavlok device and plug the other end into any charging source (e.g. a

computer or a charger). If done correctly, you should see a single LED pulsating,

indicating your Pavlok 3 is now charging.

The LED lights will advance from the red LED towards the green LED as the unit

charges. To quickly check the battery level, you can double-tap the face of the device

with your fingers.

Bluetooth pairing

We recommend you pair your Pavlok through the Pavlok 3 app. You will be prompted

to do so when you install the app, or you can press the Pavlok remote button in the

upper right corner.

Alternatively, you can pair the device through your phone or tablet's settings. Please

accept the pairing and notification requests to enable full app functionality.

Your Pavlok will vibrate twice when it is paired.

If you are having trouble pairing, visit pavlok.com/troublepairing

Turning on the device

The device automatically turns on when you plug it in the charger and remains active

as long as it's charged.

Page 1 Bluetooth pairing We recommend you pair your Pavlok through the Pavlok 3 app. You will be prompted to do so when you install the app, or you can press the Pavlok remote button in the upper right corner. Alternatively, you can pair the device through your phone or tablet’s settings. Please accept the pairing and notification requests to enable full app functionality.
Page 2 2. If a firmware update is available during any other time, you will see a firmware update banner at the top of the screen in the app - simply tap the banner to update the firmware. 3. You can also see if an update is available inside the Pavlok 3 app under Settings.
Page 3 (10 minutes) in lukewarm water up to 1 metre / 3 feet”. What this means is that, while Pavlok 3 will survive a shower, don’t take it for a swim. Don’t worry, Pavlok 3 is fully safe to use even if wet. You can use mild soap and water (or isopropyl alcohol) to clean it.
Page 4 The device has been evaluated to meet general RF exposure requirements. The device can be used in portable exposure conditions without restriction. Canada ISED ID: 23029-3 CAN ICES-3 (B)/NMB-3(B) ISED Regulatory Statements This device complies with ISED Canada license-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device.