AOB8/16 &AOB16/16 Manual
Installing the Card
Before installing the card carefully read the Address Selection and Option Selection sections of
this manual and configure the card according to your requirements. Be especially careful with
address selection. If the addresses of two installed functions overlap you will experience unpredict-
able computer behavior. If unsure what locations are available, you can use the FINDBASE pro-
gram provided on our diskette to locate blocks of available addresses.
To install the card:
1. Turn off computer power.
2. Remove the computer cover.
3. Remove the blank I/O backplate.
4. Set switches for selected options. See the option selection section of this manual.
5. Select the base address on the card. See the address selection section of this manual
6. Install the card in an I/O expansion slot.
7. Install the I/O cable.
8. Inspect for proper fit of the card and cables, tighten screws.
9. Replace the computer cover and apply power.
Page 2
Manual Number: 00650-010-6