Advertisement
WARNINGS
Following instructions must be consulted in order to obtain a correct
installation, use and maintenance of product, as well as ensuring your safety.
Still retain this documentation for future reference, even for those who will
later work on the lamp for any reason.
FEATURES
Industrial LED projector made with aluminum and plastic structure and glass
lenses. The overall dimensions are between 190mm e 270mm (H) 110mm (L),
110 mm (W).
• LED light source
• LED Colour BLUE, RED, GREEN or YELLOW
• Absorption 0,11A (MINI/MID SAFE EVO GREEN, BLUE, YELLOW), 0,09A
(MINI/MID SAFE EVO RED)
• Frequency: 50-60 Hz
• Input voltage From 90Vac to 305Vac
• Consumption 25W (MINI/MID SAFE EVO GREEN, BLUE, YELLOW), 20W
(MINI/MID SAFE EVO RED)
• Appliance with isolation class I
• Max nominal ambient temperature: +50°C
• Min nominal ambient temperature: -40°C
• IP Protection class: IP54
• Use of heat-resistant power cables, interconnection cables or external
wiring till +90°C
SAFETY RULES
Always switch off the fixture before carrying out any cleaning.
Before taking any action on it make sure it has completely cooled.
Fixture suitable for installation on normally inflammable surfaces.
Designed for direct illumination of horizontal and vertical surfaces.
LED light source: it is recommended not to fix the beam to avoid possible
permanent damage to the retina.
Device with protection degree IP54 for indoor and outdoor use. The lamps of
this device are not substitutable.
Electrical part consists of a stabilized power supply: builtin protection circuit
shuts down the device in case of open circuit, short circuit, overload or
overheating; the power supply may not be turned on even after the fault. In
this case, contact the manufacturer.
Conductor cross section min. 1 mmq.
Operating temperature: min. -40°C max. +50°C.
The luminaire must be positioned in such a way that a prolonged observation
of the luminaire is not possible at a distance of less than 3 meters.
Notes for the disposal of the device, see WEEE standards.
HOW TO USE
Open the box, extract the fixture carefully and store up the packaging.
After attaching the lamp on the ceiling or on the wall, using the brackets,
connect the power cord.
The lamp has a 3x1mmq three-core cable at the output, to be connected to
the power supply (220Vac). The connection must made in order to maintain
the IP54 degree of protection of the appliance.
Do not cover the device with plastic sheets, cloths, tissues cause it has to
dissipate the heat produced by the light source.
For cleaning and maintenance always use a damp cloth without any solvents
or acids.
For your safety, do not attempt to modify the unit.
The information contained in the following documents are subject to change
without any notice by the company.
The company guarantees the conformity of the products with the applicable
European safety and EMC.
We accept no responsibility for any damage to the product, to things and/or
people, due to improper installation and/or because of changes made to the
device, using accessories and/or electrical/electronic components are not
suitable.
It's strictly forbidden any reproduction, even partial, of the information
contained in this leaflet.
Advertisement
