Page 1
LED MOTION-ACTIVATED SECURITY LIGHT DS-90-934A Please read these instructions thoroughly prior to installation, then store in a safe place for future reference.
PACKING LIST A: Screw x 1 (Painted Green) C: Ring + Nut D: Wire Nuts B1: Screw x 1 E: Crossbar B: Screw x 2 (M4*60MM) (M4*25MM) SECURITY LIGHT F: EVA Gasket TOOLS REQUIRED (not included) Flathead Screwdriver Screwdriver Silicone Sealant Step Ladder Eye Protection Pliers...
Page 3
PREPARATION Before beginning the installation of this product, make sure all parts are present. Compare the received parts with the packing list. If any part is missing or damaged, do not attempt to install the product. Estimated Assembly Time: 30-60 minutes PRODUCT MUST BE INSTALLED BY A QUALIFIED ELECTRICIAN! 1.
Page 4
IMPORTANT: After mounting the motion-activated light, apply silicone sealant completely around the perimeter of the cover plate where the back of the cover plate meets the mounting surface. Silicone sealant prevents water from seeping into the junction box. CAUTION: Make sure the motion detector head is not UPSIDE DOWN! Rotate the motion sensor so that the controls face the detection areas.
Page 5
OPERATING INSTRUCTIONS: There are many changeable settings. Please set the settings that meet your needs. 1) TIME SETTING: Time Delay TEST: Help to quickly adjust and test the fixture. FOR TESTING ONLY. When the motion sensor detects you, the light will turn on for 6 seconds at any time (day/night). 1 MIN: the light(s) will remain on for 1 min after motion detection at night.
(2) this device must accept any interference received, including interference that may cause undesired operation. LE Innovation Inc 3651 Lindell Rd Ste D, Las Vegas, NV 89103, USA www.lepro.com + 1 866-287-2558 cs.oc@lepro.com Made in China Fabriqué en Chine...
Need help?
Do you have a question about the 3200LM and is the answer not in the manual?
Questions and answers