Table of Contents
Advertisement
VALLEY FORGE & BOLT MANUFACTURING COMPANY
4410 W. Jefferson St. • Phoenix, AZ 85043 • USA
[10]
Remove the probe from the datum disc by pulling the probe sleeve away from the fastener.
CAUTION: DO NOT USE THE YELLOW CABLE TO PULL THE PROBE OFF THE DATUM
DISC.
[11]
Remember to reattach the protective cap over the datum disc! This ensures that the datum disc
is protected from the environment and remains clean for future use.
2.2.0 406A Battery Replacement
[1]
Relocate the 406A kit to a clean work bench. Remove the 406A from the kit and place it face
down on a flat surface so that the back is exposed up.
[2]
Remove the battery compartment cover to reveal the three AA batteries.
[3]
Using one of the helper tools (HT), carefully remove each AA battery by leveraging the battery's
positive end up. The clips hold onto the batteries tightly so some feel will be required.
[4]
Dispose of the old batteries.
[5]
Install fresh batteries into the 406A unit, following the positive and negative lead indications. The
battery clips provide a tight fit so that the batteries are held in place during the use of the 406A
unit. The use of the HT may be required to ease the batteries into position.
NOTE: Never mix batches of batteries, especially old and new batteries!
[6]
Once the new batteries are installed, confirm that the 406A unit turns on.
[7]
Reattach the battery compartment cover.
2.3.0 Using the 406A Bluetooth
[1]
Turn the 406A unit over so that the back is accessible. Remove the battery compartment cover.
[2]
Locate the Bluetooth
ON/OFF Switch Location
[3]
Actuate the switch to the "BT
'~' will appear on the LCD as seen in
easily actuated using a HT.
SPC4™ SYSTEM • MODEL 406A • USER'S MANUAL
"ON/OFF"
switch within the battery compartment as seen in
.
Figure 14 - ON/OFF Switch Location
-ON"
position. The
Figure 15 - LCD Bluetooth ON
Figure 15 - LCD Bluetooth ON
- Page 14 of 21 -
"LINK"
LED will begin to blink and a new symbol
. The Bluetooth switch can be
PHONE: (602) 269 - 5748
WEB: www.vfbolts.com
Figure 14 -
Rev. 1.0
Advertisement
Table of Contents
