Pathport 6822 Manual

OVERVIEW
The Pathport® 6822 2-Port Gateway provides the full
functionality of other Pathport gateways in a compact, DIN-
rail mountable form factor.
System integrators can now easily put fully customized
universes of DMX where they're needed.
Ideal for use in NEMA enclosures. Fully compatible with
eDIN interfaces.
CONNECTIONS
The Pathport 6822 features terminal strips that can be removed
from the card to facilitate easy wiring installation or replacement.
Make the following connections, WITH THE POWER TURNED
OFF.
POWER
The 6822 is designed to run on either Power-over-Ethernet (PoE),
or on an auxiliary power supply providing between 18 and 48 volts
DC. The gateway is Class 1 PoE and will draw up to 4 Watts.
If an auxiliary supply is used, observe the correct polarity when
connecting V+ and V-. A second set of terminals are provided so
power may be daisy-chained to other cards. The earth ground
terminal must be connected to the enclosure's chassis or electrical
ground terminal to ensure EMC compliance.
DMX512
DMX connections consist of a shield and data pair. Connect DATA+
and DATA- to D1+ and D1-. Observe the same polarity convention
throughout the system. Connect the cable shield or common to the
SHLD COM terminal.
NETWORK
All network wiring should follow standard Ethernet rules and be
installed by a qualified person. As part of the installation, all wiring
should be certified under the TIA/EIA-568 standard.
DMX512 INPUTS/OUTPUTS (2)
DMX PORT A
Model 6822 2-Port Gateway
LED INDICATORS
DMX PORT B
Female RJ45
Ethernet Connector
STATUS INDICATORS
POWER
IDENTIFY
DMX INPUT
A/B
DMX OUTPUT
A/B
NETWORK
LINK/ACT
POWER IN (If PoE not in use):
18-48VDC, 4W Supply required.
Use #1001-100-48-DIN PSU or equal.
Manual
Blue. Steady glow indicates power supply is
OK. Off indicates no power.
Blue. Blinks when identify is active.
Amber. Steady glow indicates port latched to
active DMX source. Input and Output off on all
ports indicates no DMX source.
Green. Steady glow indicates port is transmit-
ting DMX. Input and Output off on all ports indi-
cates no DMX source.
Green. Flickering glow means active Ethernet
network link. Off indicates no network link.
Fastening mechanism designed
for 35 x 7.5mm DIN rail
11/06/20