Advertisement
Product Includings
MX-830, User's manual, necklace string, 2 collimating zig, 2 sets of rechargeable
batteries, Battery charger
Description of Exterior and Functions
1. Beam outlet
2. Dander label
3. ON/OFF power button
4. LCD panel
5. UP/DOWN button
6. Battery cap.
How to use
As the product is set, by default, at 5 minutes of radiation time and 200mW of output
when it is shipped out, it is advised that general users should not change the settings.
The order of normal use is as follows:
1.
Open the battery compartment on the back and insert two batteries with the
negative (-) terminals facing inside. [picture 3], [picture 4]: provided 2 sets of
rechargeable batteries and recharger.
2.
Pull out the front cap (Careless rotations may cause damage; careful attention is
required!!) [picture 5]
3.
Push the supplied transparent plastic jig into the outlet of beam. (Do not rotate
it but just pull it out when removing the jig.) [picture 6]
4.
Place the transparent jig on an affected point. [picture 2]
3
Advertisement
