Advertisement
Charge your WorkPad
Before you use your new WorkPad c3 PC companion, you need to connect the cables
and charge it for three hours. Afterwards, it takes only a few minutes a day to recharge
it during regular use.
Important:
Before using this information and the product it supports, read the general and safety
information under "Notices" in the Handbook for the WorkPad c3 PC Companion.
Danger:
To avoid a shock hazard, do not connect or disconnect any cables or perform installation,
maintenance, or reconfiguration of this product during an electrical storm.
1.
Insert the AC adapter cable into the back of the
cradle connector, and then turn off your computer.
2.
Connect the cradle to a COM
(serial) port on your computer,
and then plug the AC adapter
into a wall outlet.
3.
Charge your companion by placing it
in the cradle and making sure the cradle
light is on. As your companion begins its
3-hour charge, you can continue with the
set up process.
®
c3 PC companion
If necessary, use the included
serial port adapter.
Cradle light
Advertisement
