Features; Model Description - Deek-Robot DK-C-01 Quick Start Manual

Features:

S1:
power on, press S1 2 seconds to enter mode selection menu, press S1, choose
P-1 ~ P-4 mode.
S2:
OK / Shift key: Press to adjust the position of the LED is blinking, which LED is
blinking, S3 to adjust the value of digital tube flicker. Until you press S2, the
digital is no longer flashing.
S3:
digital display flashes, S3 adjustment digits from 0-9 successively changed.
Normal digital tube display, S3 to adjust the position of the decimal point, the
decimal point in bits 0-999 minutes; in 10 bit from 0 to 99.9 seconds; no
decimal point indicates 0-999 seconds.

Model Description:

P-1:
triggering signal is received, the relay is turned on, the timer expires, the relay
off.
A1: During the delay trigger again invalid
A2: During re-timing delay trigger again
A3: Delay trigger again during termination timing relay reset
P-2:
triggering signal is received, X start time, the end of counting relay, Y start
time, the end of counting the relay off
P-3:
Cycle Switch Mode
A1: After power relay is turned on, the end of the timing off, an infinite loop.
A2: After power relay is off, the timing turned end, an infinite loop.
Instructions:
Shenzhen Deek Technology Co., Ltd.