Uni-bond E-735AB Installation Manual

Wire Colour Function
Red Power
Black Ground
Yellow Pattern Selection
Blue Synchronization
All lights must be set to the same Flash Pattern before synchronizing
1.0 Pattern Selection
1.1 Flash Patterns
NO.
1 Quad, Alternating
2 Double, Alternating
3 Triple, Alternating
Dual
4 Quad, Alternating
Colour
5 Double, Alternating Left/Right
6 Triple, Alternating Left/Right
7 Quad, Alternating Left/Right
2.0 Synchronizing
- All lights are set to secondary by default at factory.
- One light in each group can be selected as the primary lamp and control the pattern
change in all lights of the group.
- To setup primary unit, connect the Pattern Selection (Yellow wire) to Ground (Black wire)
for 5 seconds. The light will turn off and turn on again.
2.1 Switches to Use
ON - OFF Switches can be used for Power (Red wire)
OFF - (Momentary)ON Switches can be used for pattern selection (Yellow wire)
NOTE: Only E-7315 & E-736 & E-735 can be synchronized
INSTALLATION MANUAL
Tap Yellow wire to Ground (Black wire) momentarily
Pattern
All lights must be set to the same Flash Pattern before connecting
synchronization (Blue) wires
Connect To
+12/24 VDC (Power)
-
12/24 VDC (Ground)
- 12/24 VDC (Power)
Synchronization Wire from another Unit
NO.
8 Single, Amber
9 Triple, Amber
Single
Colour
10 Quad, Amber
(Amber)
11 Quad, Amber
12 Pulse, Amber
13 Single, Blue or White
Single
14 Triple, Blue or White
Colour
(Blue
15 Quad, Blue or White
or
16 Quad, Blue or White
White)
17 Pulse, Blue or White
E-735AB & E-735AW
Pattern SAE
SAE
SAE
SAE
SAE