How To Install The Loop S Software - NAVIOP Loop S User Manual

How to install the Loop S software

1
Select the Set App to open the configurator.
2
Open the Settings dialog and make the appropriate settings.
3
Configure channels/output settings.
4
Download the Zip file containing all necessary files for the installation.
5
Extract the files created at step 4 to the root folder of a storage device that fits your MFD.
6
Make sure that the MFD is turned off and insert the storage device in it.
7
Turn the MFD on and wait until the installation is complete.
8
When the MFD has booted up, remove the storage device.
9
Activating the Loop S control bar feature.
The Loop S control bar feature should be automatically enabled when the MFD is configured
and the Loop system is correctly installed. If it does not show up, you can manually activate
the feature from the advanced system settings.
The application name (A) in the menu is the same as the name assigned in the Set App.
¼ Note:
Perform steps 6 to 9 for each MFD that you would like to operate the Loop S system.
Configuration | Loop S User Manual
A
| 21