Do you have a question about the MG708 and is the answer not in the manual?
Questions and answers
Mario Nicoletti
February 22, 2025
Bike got wet and now there is no power to drive the bike. The power comes on but nothing works.
1 comments:
Mr. Anderson
February 22, 2025
If your DWMEIGI MG708 bike got wet and has no power, follow these steps: 1. Turn off the power switch and remove the key from the battery case. 2. Allow the bike to dry completely before attempting to turn it on again. 3. Avoid exposing the bike to sunlight or rain for long periods to prevent electrical issues. 4. If the bike still does not power on after drying, check the battery charge and connections. 5. If the problem persists, consider seeking professional assistance.
Page 1
DWMEIGI MG708 ELECTRIC TRICYCLE DWMEIGI MG708 ELECTRIC TRICYCLE User Manual READ THIS MANUAL CAREFULLY BEFORE USE – FAILURE TO DO SO MAY RESULT IN INJURY, PROPERTY DAMAGE AND MAY VOID WARRANTY. KEEP THIS MANUAL FOR FUTURE REFERENCE. PRODUCTS COVERED BY THIS MANUAL MAY VARY IN APPEARANCE, ASSEMBLY, INCLUSIONS, SPECIFICATIONS, DESCRIPTION...
DWMEIGI MG708 ELECTRIC TRICYCLE Safety & Warning Riding can be a hazardous activity. Certain conditions may cause the equipment to fail without fault of the manufacturer. The product can and is intended to move, and it is therefore possible to ...
Page 3
DWMEIGI MG708 ELECTRIC TRICYCLE Never spray your bike directly and don’t get the electrical components wet (the battery connector, motor, controller, cables, handlebar controls, etc) Don’t let children under the age of 10 ride the bike. ONLY use the charger which was provided (never use a charger from a different model).
DWMEIGI MG708 ELECTRIC TRICYCLE Introduction Congratulations on purchasing a DWMEIGI pedal assisted bicycle. We hope you enjoy years of satisfactory and safe riding. Read the manual This manual is provided to help you to get the best performance, comfort, enjoyment and safety from your bicycle.
DWMEIGI MG708 ELECTRIC TRICYCLE Operation Before riding, ensure that all required fasteners are tightened to the correct torque and charge the battery prior to use. Always wear a helmet and appropriate safety equipment and always keep both hands on the handlebars and both feet on the pedals whilst riding.
DWMEIGI MG708 ELECTRIC TRICYCLE Presentation of LCD Screen Specifications of LCD Display Rated voltage: 36V Rated working current: 10mA Maximum working current: 30mA Off-state leakage current: <1uA Operating temperature: -20℃~ 60℃ Storae temerature: -30℃~ 70℃ General Operation To switch on the E-bike system and provide the power supply to the controller, hold the MODE button for 2 seconds.
DWMEIGI MG708 ELECTRIC TRICYCLE Riding Instructions The bicycle was assembled and checked before leaving the factory, nevertheless, before using for the first Check before riding it for the first time: time, check the unit thoroughly. First, check to see whether the battery is fully charged and locked.
Page 8
DWMEIGI MG708 ELECTRIC TRICYCLE , known as a "gear cluster" or "cassette". The larger the gear, the less number of rotations per rotation of the crank. The largest gear is the "lowest" and is referred to as "1". As each gear becomes smaller, it is a "higher"...
DWMEIGI MG708 ELECTRIC TRICYCLE Using Brakes All bicycle models are equipped with a front and rear wheel braking system. Brakes are used to slow the bicycle down. The braking systems may use different mechanics, however, the functionality is the same, and that is to change the energy of the moving bicycle into heat energy ("friction"):...
DWMEIGI MG708 ELECTRIC TRICYCLE Batteries and Battery Charging Before charging, you must turn the power switch to “OFF” and pull out the key. Keep the charger in a dry and ventilated condition when it’s working. Firstly, connect the output plug of the charger with the socket of the battery case properly, and then insert the input plug into the electrical outlet.
DWMEIGI MG708 ELECTRIC TRICYCLE When storing the batteries for a long period of time: Battery Storage Charge the batteries at least every 30 days to avoid capacity loss. Batteries slowly self-discharge when unused over a long period. If the battery cells are left at a critically low charge state, the lifespan and capacity will be permanently reduced.
Page 12
DWMEIGI MG708 ELECTRIC TRICYCLE Lubrication: For a long service life the following parts of your E-Bike should be regularly lubricated every half year: Front axle Chain Rear axle Freewheel Front fork and other rotation parts. ...
DWMEIGI MG708 ELECTRIC TRICYCLE For safety, longest possible service life and reliability, maintain the bicycle properly. Use the maintenance schedule below for guidance. It is very important that you check certain systems and components before each and every ride. The proper condition and function of these systems is critical to your safety.
DWMEIGI MG708 ELECTRIC TRICYCLE Troubleshooting Under-charged battery. Charge battery. Follow battery care procedures. Malfunction Possible Cause Possible Solution Battery no longer serviceable. Have battery checked. Replace if faulty. Pedal assistance not Battery charger faulty. Have charger checked. Replace if faulty.
Page 15
DWMEIGI MG708 ELECTRIC TRICYCLE Under-charged battery. Charge battery. Follow battery care procedures. Motor internal fault. Replace. Motor "clicks" / has reduced power and/or Blown fuse. Replace. shuts off Loose connectors / wiring damage. Check connectors / wiring. Replace as required.
Page 17
Other Repairs All DWMEIGI electric bike repairs which is not covered by warranty can also be repaired at authorised service centre at the customers cost. We will carry most of the spare parts on our current and past models. Should you wish to purchase any parts, please contact us.
Need help?
Do you have a question about the MG708 and is the answer not in the manual?
Questions and answers
Bike got wet and now there is no power to drive the bike. The power comes on but nothing works.
If your DWMEIGI MG708 bike got wet and has no power, follow these steps:
1. Turn off the power switch and remove the key from the battery case.
2. Allow the bike to dry completely before attempting to turn it on again.
3. Avoid exposing the bike to sunlight or rain for long periods to prevent electrical issues.
4. If the bike still does not power on after drying, check the battery charge and connections.
5. If the problem persists, consider seeking professional assistance.
This answer is automatically generated