Download Print this page

RapID Lab CR1500 Instructions

Download this manual

Setting up CODE CR1500 Scanner for RapID Tags as a USB keyboard

The instructions below will program the CODE CR1500 Scanner to properly decode the

RapID Tag Data matrix symbols. More information may be found on the RapID Lab

website:

http://rapidlab.com/scanner-and-software-support/

1. Unplug the CODE CR1500 from the PC.

2. While holding the trigger pressed, plug the reader into the USB port on the PC and

hold for 5-10 seconds. You will hear 5 rapid beeps and then you can let go of the

trigger. The unit is now in Boot Mode.

3. To reset the CODE CR1500, simply hold the trigger down again for approximately 5-

10 seconds until it reboots. The reader will vibrate first and then beep several times

and is now reset.

4. Next, simply scan the following codes shown in the table below.

Required Codes:

Remove previous programming

Additional optional codes on the page below.

Custom settings requiring

suffix <Enter>

Page 1 5-10 seconds. You will hear 5 rapid beeps and then you can let go of the trigger. The unit is now in Boot Mode. 3. To reset the CODE CR1500, simply hold the trigger down again for approximately 5- 10 seconds until it reboots. The reader will vibrate first and then beep several times and is now reset.
Page 2 3. This code creates a 1 second delay between scans. 3. 1 Second Duplicate Scan Delay 4. This code creates a 3 second delay between scans. 4. 3 Second Duplicate Scan Delay Copyright © 2013 RapID Lab, Inc. All rights reserved.