Download Print this page

RapID Lab CR1400 Instructions

Please note that RapID Lab highly recommends upgrading to the CR1500 scanner if

you haven't already. The CR1500 provides a faster and more reliable scan for your

workflow.

Setting up CODE CR1400 Scanner for RapID Tags as a USB keyboard

The instructions below will program the CODE CR1400 Scanner to properly decode the RapID Tag

Datamatrix symbols. More information may be found on the RapID Lab website:

www.rapidlab.com/support

1. Unplug the CODE CR1400 from the PC.

2. While holding the trigger pressed, plug the reader into the USB port on the PC and hold for 5-10

seconds. You will hear 5 rapid beeps and then you can let go of the trigger. The unit is now in Boot

Mode.

3. To reset the CODE CR1400, simply hold the trigger down again for approximately 5-10 seconds until

it reboots. The reader will vibrate first and then beep several times and is now reset.

4. Next, simply scan the following codes shown in the table below.

Table of Contents

Do you have a question about the CR1400 and is the answer not in the manual?

Page 1 You will hear 5 rapid beeps and then you can let go of the trigger. The unit is now in Boot Mode. 3. To reset the CODE CR1400, simply hold the trigger down again for approximately 5-10 seconds until it reboots. The reader will vibrate first and then beep several times and is now reset.
Page 2 Continuous Scan mode by default when placed in the Scanner Stand. This sets a duplicate rejection period of 0, 1, or 3 seconds so that tags are not ‘double scanned’. Copyright © 2013 RapID Lab, Inc. All rights reserved.