Troubleshooting - SP tools SP61073 User Manual

6. Once the vehicle has started turn the power button to the "OFF" position, remove
jumper cable from Li
vehicle battery terminals.
7. Note: Once the engine is running, be sure to allow enough time for the vehicles
alternator to restore charge to the vehicles battery before turning it off again.

7. Troubleshooting

FAULT
LED display shows a solid
red "8" accompanied by
long continuous beeping.
LED display shows solid red
"8" accompanied by short
continuous beeping.
LED display shows solid red
"8" accompanied by short
fast continuous beeping.
LED display shows solid red
"8" accompanied by 2 short
fast beeps.
LED display flashing
Green/Red "8".
All error codes with a solid red "8" being displayed can be reset by turning the Li
Power Bank off and on.
+ Power Bank and disconnect RED and BLACK clamps from the
Reverse polarity
connection.
Jumper leads are
connected to the wrong
terminals on the vehicles
battery.
Short circuit protection.
There is a short circuit
between the jumper leads.
Over-heat protection.
The Li
+
become too hot.
Over-discharging
protection.
The Li +
on charge.
The Li +
searching for a connection.
CAUSE
Power Bank has
Power Bank is low
Power Bank is
REMEDY
Remove jumper leads from
battery and connect them to
the correct terminals as per
instructions on page 8 of
this owner's manual.
Remove clamps from
vehicle battery, check for
short circuits. If short circuit
is caused by damage to the
jumper leads, discontinue
use until replacement leads
are available.
Remove clamps from
vehicle battery, Allow the
unit to cool sufficiently
before next use.
Recharge the Li Cobalt
+
Power Bank.
Ensure battery terminals
are clean (free from
corrosion) and re-check
connections.
+ Cobalt
9