Continuous Measurement; Area Measurement - NWI LSC60 Manual

Jump to
Also user can jump to desired record. If user wants to go to the 13th
record, user can press 1, then 3, and press
jump to the 13th record.
Delete
Long press to delete the selected record.
Calculate
When viewing record, press + - x ÷ to calculate another record or input
number.
Quit
Press to go back to single distance measurement interface.
5. Measurement
Single Distance Measurement
Follow the steps below to take single distance measurement.
(1) Press to activate the laser, and aim at the object which is to be
measured.
(2) Press again to take measurement. Results will be seen on display
immediately.
Laser Site Calculator LSC60 Laser Site Calculator LSC60
WR FRQÀUP WR GLUHFWO\
View

Continuous Measurement

Long press button, until you hear beeps,
to activate continuous measurement. Under
this mode, minimum or maximum distance
can be measured from a fixed measuring
position by sweeping ideal points.
It's usually used to find the right angle and
diagonal. As shown in Figure (D), user
can press or to stop continuous
measurement, and the values of minimum
and maximum distances are shown in the
display as well as the last measured value in
the summary line.

Area Measurement

Press once, the symbol
Press WR WDNH WKH ÀUVW GLVWDQFH PHDVXUHPHQW HJ /HQJWK 
Press again to take the second distance measurement (e.g. width).
The results of length, width, perimeter and area will be seen on display
orderly.
4 4
Figure (D)
appears on display.
LSC60
EN