Advertisement
Quick Links
MOUNTING INSTRUCTIONS
SCREWING ABSORBERS
These instructions are for the following products: spectrum A10, spectrum A20, spectrum P816.
UNBOXING
Open the package carefully! Inserting sharp objects
into the package can damage the absorber. Avoid
using long, sharp tools for opening the package!
DETERMINE THE
MOUNTING POSITION
While determining the mounting positions, it helps
to mark the walls and ceiling using a level and
tape measure, in order to achieve even spacing in
relation to corners and sound sources.
TOOLS
The following tools are needed for installation:
✓ Box Cutter/
✓ Folding ruler or
utility knife
tape measure
✓ Level
✓ Electric drill
✓ Pencil
✓ Drill bits
Make sure to use the correct type of anchors for your
mounting surface (drywall, masonry, concrete, etc.).
REMOVE PRODUCTS
FROM PACKAGING
Carefully remove the products from the package and
remove the protective film. Also remove the drilling
template and mounting clips and set them aside.
EN
✓ (Electric) Screwdriver
✓ Anchors (6-8)
✓ Screws
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for t.akustik spectrum A10
Summary of Contents for t.akustik spectrum A10
- Page 1 MOUNTING INSTRUCTIONS SCREWING ABSORBERS These instructions are for the following products: spectrum A10, spectrum A20, spectrum P816. TOOLS The following tools are needed for installation: ✓ Box Cutter/ ✓ Folding ruler or ✓ (Electric) Screwdriver ✓ Anchors (6-8) utility knife tape measure ✓...
- Page 2 MARK AND DRILL HOLES USING THE TEMPLATE Position and align the drilling template on the wall. Use the template to mark the drilling locations through the paper using a pencil. Then drill the holes. INSERT ANCHORS, SCREW IN MOUNTING CLIPS Insert anchors into the holes and use screws to securely attach the four mounting clips for installing the absorber.
Need help?
Do you have a question about the spectrum A10 and is the answer not in the manual?
Questions and answers