Advertisement
3 Set the flag gear spring on the post as shown.
Picture opposite shows the gear, in the correct
reset position. The tail of the spring fits into a
notch at the base of the gear shaft.
The teeth of the reset gear should start to
mesh with the other gear.
4. Re install the gear cover plate and 2 screws.
You are now ready to replace your cartridge in
the printer and resume printing
www.zinetic.co.uk
Toner that doesn't cost the earth
Printed on recycled paper, using refilled cartridges
If no gear is present, you can purchase a replacement
gear, please contact us.
email:
sales@zinetic.co.uk
Advertisement
