The assembly steps must be followed, as must the operating instructions, and safety rules must always be heeded. Before installing the shutter motor, check that both the driven part and the entire WIBAT APPLIQUE are in good physical condition and that the structure has the necessary load-bearing capacity for the WIBAT APPLIQUE in its entirety.
Page 3
MANTION SMT products come with a 5 (five) year guarantee from the date of delivery. The guarantee is limited, as decided by MANTION SMT, either to replacement or to repair of products MANTION SMT recognizes as faulty, with the proviso that: 1.
Technical Characteristics WIBAT APPLIQUE is designed for opening and closing swing shutters (one or two leaves). It is designed for domestic use. Product with a 230 V power supply Product with a 24 V power supply Minimum width per leaf 0.40 m*...
Page 6
The SRX 8-60 wall plugs are supplied only for fixing in concrete, solid and hollow breeze-blocks MANTION SMT Adresse postale : 2 rue des Métiers 21110 Genlis Tél. : (33) 03 80 37 85 71 Fax : (33) 03 80 37 88 61...
Page 7
The SRX 8-60 wall plugs are supplied only for fixing in concrete, solid and hollow breeze-blocks MANTION SMT Adresse postale : 2 rue des Métiers 21110 Genlis Tél. : (33) 03 80 37 85 71 Fax : (33) 03 80 37 88 61...
Page 8
Adjust the strap or hook-and-eye hinges to solve this problem, because this could prevent the WIBAT APPLIQUE from working properly. MANTION SMT Adresse postale : 2 rue des Métiers 21110 Genlis Tél. : (33) 03 80 37 85 71 Fax : (33) 03 80 37 88 61...
Page 9
Place the sleeve at the bottom of the plate, thread the cables through the sleeve again and fasten them with the cable clip Routing the cables downwards MANTION SMT Adresse postale : 2 rue des Métiers 21110 Genlis Tél. : (33) 03 80 37 85 71 Fax : (33) 03 80 37 88 61...
Page 10
Mark out the 4 points Drill a 60-mm hole with an 8-mm masonry bit MANTION SMT Adresse postale : 2 rue des Métiers 21110 Genlis Tél. : (33) 03 80 37 85 71 Fax : (33) 03 80 37 88 61...
Page 11
Place level E on the footing so that the face of the product is vertical. Tighten the screws with the 2.5-mm hexagonal key. MANTION SMT Adresse postale : 2 rue des Métiers 21110 Genlis Tél. : (33) 03 80 37 85 71 Fax : (33) 03 80 37 88 61...
Page 12
With pencil A, mark the position of the centreline of the roller on the open shutter. MANTION SMT Adresse postale : 2 rue des Métiers 21110 Genlis Tél. : (33) 03 80 37 85 71 Fax : (33) 03 80 37 88 61...
Page 13
Close the shutter and mark the position again. Slide the roller in the rail MANTION SMT Adresse postale : 2 rue des Métiers 21110 Genlis Tél. : (33) 03 80 37 85 71 Fax : (33) 03 80 37 88 61...
Page 14
Make sure the rail is level then tighten the screws. MANTION SMT Adresse postale : 2 rue des Métiers 21110 Genlis Tél. : (33) 03 80 37 85 71 Fax : (33) 03 80 37 88 61...
Page 15
2 M4 screws 5 – Repeat steps 2, 3 and 4 for the second shutter MANTION SMT Adresse postale : 2 rue des Métiers 21110 Genlis Tél. : (33) 03 80 37 85 71 Fax : (33) 03 80 37 88 61...
If the cables are damaged, contact our after-sale department. Identification of motors. The leaf with the overlap is the first to open. As standard the WIBAT APPLIQUE is prepared for shutters with an overlap as shown in the figure below. Overlap...
Page 17
For your safety: check that the installation is powered down when connecting. Terminals Phases Colour Phase Brown Neutral Blue Earth Yellow/Green MANTION SMT Adresse postale : 2 rue des Métiers 21110 Genlis Tél. : (33) 03 80 37 85 71 Fax : (33) 03 80 37 88 61...
Page 18
For your safety: check that the installation is powered down when connecting. Terminals Phases Colour Phase Brown Neutral Blue Earth Yellow/Green MANTION SMT Adresse postale : 2 rue des Métiers 21110 Genlis Tél. : (33) 03 80 37 85 71 Fax : (33) 03 80 37 88 61...
Page 19
For your safety: check that the installation is powered down when connecting. The power supply connection must comply with the recommendations of its manufacturer. MANTION SMT Adresse postale : 2 rue des Métiers 21110 Genlis Tél. : (33) 03 80 37 85 71 Fax : (33) 03 80 37 88 61...
Page 20
For your safety: check that the installation is powered down when connecting. The power supply connection must comply with the recommendations of its manufacturer. MANTION SMT Adresse postale : 2 rue des Métiers 21110 Genlis Tél. : (33) 03 80 37 85 71 Fax : (33) 03 80 37 88 61...
Page 21
(Open button when opening in progress) (Button closure if closure in progress. WIBAT APPLIQUE is equipped with a current-measuring safety device. If any obstacle is encountered when the shutter is opening or closing, the shutter reverses its direction and returns to its initial position.
The LED flashes quickly then goes out: the switch is now peered. MANTION SMT Adresse postale : 2 rue des Métiers 21110 Genlis Tél. : (33) 03 80 37 85 71 Fax : (33) 03 80 37 88 61...
When the card is in "radio disable" mode, a short press on the setup button will turn off the LED, and the card will revert to normal operating mode. MANTION SMT Adresse postale : 2 rue des Métiers 21110 Genlis Tél. : (33) 03 80 37 85 71 Fax : (33) 03 80 37 88 61...
Page 24
Blue on blue and brown on brown. Connect Brown wire Connect Blue wire MANTION SMT Adresse postale : 2 rue des Métiers 21110 Genlis Tél. : (33) 03 80 37 85 71 Fax : (33) 03 80 37 88 61...
Mount the cover on the system then clip on the 3 trim covers. MANTION SMT Adresse postale : 2 rue des Métiers 21110 Genlis Tél. : (33) 03 80 37 85 71 Fax : (33) 03 80 37 88 61...
Page 26
The shutter does not close and / or does not open completely MANTION SMT Adresse postale : 2 rue des Métiers 21110 Genlis Tél. : (33) 03 80 37 85 71 Fax : (33) 03 80 37 88 61...
Need help?
Do you have a question about the WIBAT APPLIQUE and is the answer not in the manual?
Questions and answers