Related Manuals for Reactor Heavy Water 100-lap
Summary of Contents for Reactor Heavy Water 100-lap
- Page 1 IMPORTANT! Register for your warranty Heavy Water 100-lap Instructions & Warranty online at www.reactorwatch.com p/n 10009 rev9-12...
- Page 2 While your REACTOR watch is built for ALWAYS RINSE YOUR HEAVY WATER maximum durability, it should ALWAYS be WATCH THOROUGHLY IN FRESH WATER rinsed thoroughly after use in salt water.
- Page 3 Heavy Water Features Your Heavy Water has these functions: 1) Normal time Press B3 for temp, B4 for Time 2 4) Chronograph with 100-lap memory 5) Recall of lap times in 9 segments 6) Countdown timer 7) Alarm Pressing B2 advances through these functions in the order shown.
-
Page 4: Setting The Time
Setting the Time 4) Set unit (F or C) for temp display 5) For Offset, see Temp instructions on With the watch in normal Time mode, the following pages. press and hold B1 to enter SET mode. Press B1 again to exit SET mode. Press B3 to increase or B4 to decrease While in normal time mode, you can: value. - Page 5 Time 2 Mode The Time 2 mode allows the watch to display a second time zone, and includes a second calendar to accommodate distant locales that may be a day ahead or behind your normal time setting. Time 2 can be viewed quickly by a press of B4 while in normal time mode.
- Page 6 Adjusting the Temp function as the final step of the time set procedure. To determine the offset, With the watch in normal Time mode, wear the watch in a room of known press B3 to see the current air or water temperature for at least 15 minutes.
-
Page 7: Using The Chrono
Using the Chrono Press B2 to enter CHRONO mode. The amount of free memory will display briefly before switching to chrono view. 1) Press B3 to start the chrono. 2) Press B3 again at the conclusion of each lap. Lap time will display for 10 secs then change to new lap time. - Page 8 Lap Memory Recall IMPORTANT! Run segments must be saved in CHRONO mode to be available in RECALL mode. See prior pg. for details. Although your watch has 100-lap memory, this memory can only be divided into nine segments (RUNs 1-9). Once all nine segments are used (even if lap memory is still free), saving an additional segment will delete RUN 1 and...
- Page 9 RECALL mode continued... To view a different segment, press B3 to return to the segment select screen and To enter RECALL mode, press B2 until B3 again to change the segment. RECALL is displayed. The watch will then display the last segment recorded along To delete a particular segment, while with the date it was recorded.
-
Page 10: Countdown Timer
Countdown Timer The Timer has three modes that change what happens when the timer reaches From the time mode, push B2 three zero. CD-STP is countdown stop, which times to enter Timer mode. Push and will countdown once and stop. CD-UP hold B1 to enter set mode - the current is countdown –... -
Page 11: Using The Alarm
Using the Alarm To set the alarm, press and hold B1. Choose the desired alarm type by From time mode, press B2 four times to pressing B3, then press B2 to advance enter alarm mode. There are three types to the time setting. Press B3 or B4 to set of alarm - daily, weekly and scheduled. -
Page 12: Warranty
Our warranty is simple and straight If your watch needs service, return it to: forward: if anything goes wrong with Reactor Service your REACTOR watch in the first two 5312 Derry Ave., Suite B Agoura Hills, CA 91301 years of ownership, we will either repair or replace it at our expense.
Need help?
Do you have a question about the Heavy Water 100-lap and is the answer not in the manual?
Questions and answers