Morning Protocol For The Application Of Your Prose Device - BostonSight PROSE Use And Care Manual

Morning Protocol for the Application of Your PROSE Device

You will need to have a soft towel to be placed on top of a clean work surface where you
1
will apply your device(s).
You will need the following supplies:
2
• An application plunger
• A removal plunger
• A small mirror
• Preservative-free saline, prescribed for you
After thoroughly washing and drying your hands with non-moisturizing soap and water,
3
remove your device from the PROSE disinfection case.
While holding a cleaned and disinfected PROSE device gently by the edges, briefly rinse
4
with preservative-free saline, prescribed for you. Under no circumstances should tap
water be used for rinsing.
Apply device(s) to the eye(s) using your preferred application technique.
5
After each use, empty the PROSE disinfection case (being careful not to lose the neutralization
6
disc) and leave it open to air dry. NEVER clean the PROSE disinfection case with alcohol.
NOTE: If you experience a slight stinging sensation upon application of the device in the
morning, remove your device from your eye immediately and rinse your eye thoroughly
with preservative-free saline, prescribed for you. Do this until the stinging sensation
dissipates. Rinse your device(s) thoroughly with preservative-free saline and then soak
them in fresh saline solution for at least 5 minutes before re-applying to your eye. When
this occurs, it is likely an indication that the Clear Care catalyst needs to be replaced.
WARNING
Increased eye redness, pain, discharge, sensitivity to light, and/or significant reduction in
vision may signal infection and requires IMMEDIATE attention. Please contact your primary
eye care provider and ask them to keep your PROSE doctor aware of any findings.
BostonSight PROSE Device Use and Care Guide
disinfection and care a.m.
17