Nightly Disinfection Protocol For Your Prose Device - BostonSight PROSE Use And Care Manual

disinfection and care p.m.

Nightly Disinfection Protocol for Your PROSE Device

Wash your hands thoroughly with non-moisturizing soap and dry completely with a
1
lint-free towel before you begin.
Place your device in the palm of your hand. Place one drop
2
of Optimum ESC by Lobob or MiraFlow Extra-Strength Daily
Cleaner, or Unique pH or Boston Simplus (for plasma-
treated) or Unique pH, Boston Simplus, or Tangible Clean (for
Hydra-PEG treated) on the outside surface of the device and
rub for fifteen seconds. Place another drop on the inner surface
and then rub again for fifteen seconds.
DO NOT rub the device between your fingers to clean it.
This can cause the device to warp.
While handling the PROSE device gently by the edges, rinse
3
the device thoroughly with preservative-free saline prescribed for you, B&L Sensitive
Eyes Plus saline or Clear Care Rinse & Go. Under no circumstances should tap
water be used for rinsing.
Gently separate the basket from the basket assembly by pulling the tab
4
located near the arbor so that the basket is horizontal.
Place the right device, bowl side up, into the white basket (see photo at
5
right for correct placement). While keeping the basket horizontal, bring
the basket assembly down onto the basket. To avoid damaging or
losing your PROSE devices, DO NOT attempt to bring the
basket up to the basket assembly.
Repeat for the left device and place into the empty basket.
6
Fill the PROSE disinfection case with Clear Care solution to the fill line.
7
It is ok if the neutralization disc floats up to the top – the basket will push it back down.
Place the basket assembly in the case and secure the cover. DO NOT over tighten the
8
cover because the threads may split and break. It is ok if the disc does not sit flat at the
bottom of the case. It will still work properly, even if it is wedged on the side of the case.
To properly allow the Clear Care solution to neutralize, devices must remain in the case
for AT LEAST six hours. NOTE: If you must remove the devices before the disinfec-
tion process has ended, rinse them thoroughly with the saline, prescribed for you. Then
soak devices in fresh saline, in a clean contact lens case for at least 5 minutes.
Repeat with fresh saline solution for an additional 5-minute soak. Rinse again with
preservative-free saline before re-applying to your eye. Clean the white contact lens
case with an alcohol wipe and air dry.
16 BostonSight PROSE Device Use and Care Guide