1. Manuals
  2. Brands
  3. i-milk Manuals
  4. Dispenser
  5. i-milk
  6. Operating manual

i-milk Operating Manual

Hide thumbs
Table of Contents

Advertisement

Quick Links

Download this manual
Operating Manual
Please read thoroughly before use
Page
1
OPERATING MANUAL VERSION 3 | LAST UPDATED APRIL 2020
i-milk V3 Operating Manual August 2019

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the i-milk and is the answer not in the manual?

Questions and answers

Related Manuals for i-milk i-milk

Summary of Contents for i-milk i-milk

  • Page 1 Operating Manual Please read thoroughly before use Page OPERATING MANUAL VERSION 3 | LAST UPDATED APRIL 2020 i-milk V3 Operating Manual August 2019...

  • Page 2: Warranty

    The warranty will be void if the equipment is not installed in accordance with the directions from I-milk or if not used in accordance with the 2. Freezing the milk lines or even the milk in the pumps may also cause operating instructions in this manual.

  • Page 3: Table Of Contents

    8. Milk Dump Settings ................................15 9. Technical Adjustments .................................16 10. Trouble Shooting ................................18 11. Menu Maps ..................................19 12. Screen Messages ................................21 13. Deep Cleaning Service Record (Annual) .......................... 22 Maintenance Record ............................Yellow Pages Page i-milk V3 Operating Manual August 2019...

  • Page 4: Familiarisation

    4 core cable goes to the pump box – and the fatter 8 core cable goes to the dispensing head unit. Pump Box Input Head Unit Input AC Power Source 10AMP Power Lead Page i-milk V3 Operating Manual August 2019...
  • Page 5 Should circumstances or preference change after you have installed referred to as Milkstaks or in sliding drawers. your i-milk, it can be reconfigured or expanded at a later time to take advantage of one of the other milk storage options available to you.

  • Page 6: Essential Maintenance

    Inspect Load Cell Water Proofing (Dam) Membrane. See page 17 . Clear drain hose of sediment. To do this remove drain hose and pressure rinse using hot water to remove any internal sediment. Page i-milk V3 Operating Manual August 2019...

  • Page 7: Loading Milk Bladders

    Correct Way To Load A Bladder Take care when sliding bladder connector into slot. Otherwise the cap may be pulled off resulting in a loss of milk. Page i-milk V3 Operating Manual August 2019...
  • Page 8 To Top-Up A Filled Jug Lift the jug when pouring stops and replace it to add more milk, i-milk will detect the jug size and fill your jug with full cream milk to removing it when filled to the desired level.

  • Page 9: Operating Instructions

    To Exit Sleep Mode Access the Menu and the message will appear REMAIN ASLEEP on the screen Tap the jug rest once to the message WAKE ME UP and cross the Selector. Page i-milk V3 Operating Manual August 2019...

  • Page 10: Programming I-Milk

    Repeat the process for each Jug size. To return back to When you have finished calibrating I-MILK READY i-milk checks the weight of jugs to determine the volume of milk your jugs tap the jug rest until EXIT MENU and cross the Selector.
  • Page 11 The volume is the amount of Hot Chemical needed to completely fill the plumbing system for each milk type. Cross the sensor and place the filled jug on the jug rest. I-milk will weigh it and use that weight for your cleaning volumes. Now pour Please record the volumes in this manual here : the coloured water back into the 5 litre container.
  • Page 12 The standards of HACCP Australia requires that every 12 months appear. i-milk and in particular the pumps be dismantled and inspected for any build up of milk stone and if necessary, affected parts must be cleaned or replaced. The annual physical deep clean...
  • Page 13 CLEANING INSTRUCTIONS Cleaning Instructions (Procedure) Chemical Cleaning the Milk Lines cont. Daily Cleaning Of The I-Milk Dispenser With on the screen place an empty ADD HOT CHEM AND PLACE JUG cleaning jug on the jug rest After pumping chemical into both milk lines the message will appear.

  • Page 14: Cleaning Instructions

    After manual cleaning, drain the milk system - for Milkstak After the milk dispenser has been cleaned, wake up i-milk through the menu. Remove all water from the full cream milk lines by placing the large jug on the dispenser.

  • Page 15: Cleaning Log

    On each day that the dispenser was cleaned there will appear a On each day the dispenser was not cleaned there will appear a – To exit, cross selector and tap the jug rest to EXIT and cross selector. Page i-milk V3 Operating Manual August 2019...

  • Page 16: Milk Dump Settings

    The message DISCARD LITE will remain on the display until the jug is removed. DISCARD LITE After the milk has been dumped and the jug is removed the i-milk will return to the I-MILK READY mode.
  • Page 17 TECHNICAL ADJUSTMENTS Technical Adjustments To Clean the Milk Filter Housing Cleaning The Milk Lines i-milk has a milk filter located on the font outlet. This black Gently clean each mesh filter in fitting delivers uniform, warm soapy water and then re-...

  • Page 18: Technical Adjustments

    The water proofing dam prevents waste water from entering the head unit should the dispenser sink be over filled with waste. Each month inspect that the dam is in place and is not damaged. To inspect the dam put your i-milk to sleep by selecting from the scrolling menu...

  • Page 19: Trouble Shooting

    Milk Transfer mode from the scrolling menu. The jug rest is not properly located onto the jug rest locator. To rectify, put i-milk to sleep, remove and reapply the jug rest. The metal sensor requires adjustment.

  • Page 20: Menu Maps

    JUGS ALLOWED JUG 3-2 BACK JUG 4-1 EXIT MEN JUG 4-2 BACK EXIT MENU FIRMWARE RAW WEIGHT WEIGHT SWING VIEW INFO TIME VERSION CLEANING LOG SEE PAGE 13 SLEEP MODE SEE PAGE 8 EXIT Page i-milk V3 Operating Manual August 2019...
  • Page 21 TIME LITE VOL DUMP TIMEOUT DATE PULSE VOL BACK SUMMER TIME BACK EXIT MENU TIME ZONE EXIT MENU CALIBRATION RE RINSE PASSWORD CHANGES PASSWORD UPDDATE VIA USB BACK BACK EXIT MENU EXIT MENU Page i-milk V3 Operating Manual August 2019...

  • Page 22: Screen Messages

    JUG 1, JUG 2, JUG 3 medium jug, and Jug 3 is the large jug. These are the jugs that have been specifically calibrated for your i-milk. This message appears as a jug is being filled and indicates which fill level is selected.
  • Page 23 DEEP CLEAN SERVICE RECORD Deep Clean Service Record (Annual) HACCP requires i-milk be Deep Cleaned every 12 months in order to remain certified. This record details the steps. Maintenance Procedure Date of Service Date of Service Date of Service Date of Service...
  • Page 24 MAINTENANCE RECORD Maintenance Record WEEKLY MONTHLY DATE NAME CHECK RECALIBR ATE CHECK MILK LUBRICATE CHECK LC CLEANING LOG MILK JUGS FILTER “O” RINGS PROOFING Page i-milk V3 Operating Manual August 2019...
  • Page 25 MAINTENANCE RECORD Maintenance Record WEEKLY MONTHLY DATE NAME CHECK RECALIBR ATE CHECK MILK LUBRICATE CHECK LC CLEANING LOG MILK JUGS FILTER “O” RINGS PROOFING Page i-milk V3 Operating Manual August 2019...
  • Page 26 MAINTENANCE RECORD Maintenance Record WEEKLY MONTHLY DATE NAME CHECK RECALIBR ATE CHECK MILK LUBRICATE CHECK LC CLEANING LOG MILK JUGS FILTER “O” RINGS PROOFING Page i-milk V3 Operating Manual August 2019...
  • Page 27 MAINTENANCE RECORD Maintenance Record WEEKLY MONTHLY DATE NAME CHECK RECALIBR ATE CHECK MILK LUBRICATE CHECK LC CLEANING LOG MILK JUGS FILTER “O” RINGS PROOFING Page i-milk V3 Operating Manual August 2019...
  • Page 28 Page i-milk V3 Operating Manual August 2019...

Table of Contents