Zip Water Zip HydroTap G4 BCS100/75 Installation And Operating Instructions Manual page 16

NOTE 1: This appliance is intended for use with the Zip HydroTap Command Centre.
NOTE 2: Water connections must be pointing vertically upwards.
NOTE 3: The booster unit should be installed as close as possible to the Zip
HydroTap Unit as the 400mm connection hoses cannot be lengthened.
3.4
Braided hose connections
1. The cold water inlet (blue) and hot water outlet (red) are marked on the rating plate. Connect the
braided hoses from the 'Bypass Out' fitting to the water inlet of the booster unit (marked blue) and
from the outlet of the booster unit (marked red) to the 'Bypass IN' fitting on the Zip HydroTap unit.
Avoid exerting any mechanical pressure on the appliance. This can be achieved by applying a spanner
on the flats of the inlet and outlet connections when tightening the braided hose connectors. Do not
overtighten! Tighten the braided hoses by hand, then turn an additional 90° - 180° with a spanner
2. Once the water connections have been made, check for any leaks and rectify as necessary.
Typical Installation
Braided Hoses
Strainer
Cold Water
Connection
(inlet, G1/2")
Hot Water
Connection
(outlet, G1/2")
Page 16 of 32
Booster Installation
Hold the hexagon while
tightening the braided
hose fittings
802265 v3.05 09.20 HT BCS Compact Commercial Instructions