Advertisement
Installation introduction
Chapter 3
Attention:
A.The temperature measuring equipment should be used in the room between room
temperature, do not install the temperature measuring equipment under the vent, to
ensure that there is no heating source within 3 meters;
B. When people enter the room from the cold outdoor environment, the
temperature measurement accuracy will be affected. The forehead temperature test
shall be conducted after the forehead is not blocked for three minutes and the
temperature is stable.
C. The temperature read by the temperature measuring device is the temperature of
the forehead temperature area. When there is water on the forehead, sweat stains,
l
oil stains or heavy makeup or wrinkles in the elderly, the temperature read will be
ower than the actual temperature, to ensure that there is no hair or clothing cover.
1. Brake (column) installation:
t
1.1 According to the requirements of the installation site, a hole with a diameter of 35mm should be opened at
he spatial location of the brake, generally in the middle or in the front side, for the installation of the access
control machine column (outside diameter of the column hole is 34mm). The hole opening position is suggested
by the star as shown in the figure
Single channel brake
1.2 Adjust the angle of the temperature collector
After the temperature measuring access control machine is fully started, the face is directly facing the device,
and the face image on the screen of the device is observed. The face ensures that the exposed skin on the
forehead is placed in the "temperature measuring area" (the optimal temperature collection distance is 0.5m).
After the position is determined, the corresponding detection position marker (please stand here) is affixed to
the distance
www.olexla.com
info@olex.la
Double channel brake
4
User Manual
Advertisement
