Page 1
Adlonco Holdings Owner’s Manual Rafter 1” x 1” Add a room Model No. E0806 E1107 E1508 E1809 E2210 E2611 (96” at the wall) G0806 G1107 G1508 G1809 G2210 G2611 (88” at the wall) H0806 H1107 H1508 H1809 H2210 H2611 (107” at the wall)
SAFETY, PRE-ASSEMBLY & INSTALLATION SAFETY 4. As a minimum, you will need the following tools to assemble and install your Add-A-Room: CAUTION Electric or cordless drill ” & ” drill bits Before attempting to install this Add-A- #2 Robertson (square) screwdriver Room, read this manual and follow all its ...
Page 3
INSTALLATION INSTALL REAR ROOF TRACK – cont’d 2. Remove screen section where the door frame is to be located by sliding the vinyl hinge on each side of the 4. Draw a line (4) down the wall at each end of the rear screen section upward until they are removed from roof track.
Page 4
INSTALLATION INSTALL DOOR & HANDLES 2. Align the top of one wall against the house with the outside edge of the screen frame 1¼” inside the 1. Slide door (wheels down) into plastic door tracks and vertical mark on the wall (see Fig 8). move it to the closed position.
Page 5
INSTALLATION INSTALL FRONT AND SIDE TOP EXTRUSIONS 7. Install side extrusions (1) onto top of screen panels (2) of each side wall (see Fig. 12). 1. Install front top extrusion (1) onto top of front screen NOTE: Side extrusions should overhang the outside panels (2) (see Fig.
Page 6
INSTALLATION INSTALL SQUARE ROD HOLDERS AND RODS 1. Insert square rod holders (1) into slots in the bottom of the front and side top extrusions (2) on the outside of the screen panels (3) (see Fig 14). NOTE: Equally space three rod holders above each screen panel and the door.
Page 7
INSTALLATION INSTALL ROOF – cont’d 6. Beginning at one end, push the square rod and rod pocket (4) into the slot (5) in the upper part of the rear roof track (see Fig. 17.). NOTE: Make sure the end of the square rod and rod pocket are to the end of the rear roof track.
MAINTENANCE, STORING & PARTS PARTS AVAILABILITY MAINTENANCE LEAKS GENERAL NOTE: It is normal for small needle holes to be visible All replacement parts are guaranteed to be as where vinyl has been stitched. Unlike cloth fabrics, vinyl represented. We will always do our very best to fill your material will not contract after being pierced with a sewing parts order promptly.
Need help?
Do you have a question about the E0806 and is the answer not in the manual?
Questions and answers