Download Print this page

Calf-Tel MultiMax Assembly Instructions

Download this manual

Thank you for buying a Calf-Tel MultiMax Hutch. We recommend that you:

Check you have all the fixings and equipment you need

Assemble the timber base

Assemble the MultiMax hutch

Attach the hutch to the base.

Attach reinforcing brackets and bedding door

latches.

We suggest you leave the panels for a day or two

after delivery to regain their natural shape before

assembling them.

Equipment

You will need:

 Drill with 6mm and 8mm bit

 8mm socket and spanner, 11mm and 17mm sockets

 Cross head screwdriver

 A helper for stage 3

You should have received the following components from us:

Component

MMH Back with Rear Bedding Door

MMH Right Side

MMH Left Side

MMH Roof

MMC Timbers Front / Back 2.5m x 100mm x 100mm

MMC Timbers Side 2.14m x150mm x 100mm

MMH INS 1063A Knockdown Fixing Pack 2020 including:

AH-151-1 MultiMax self assembly fixing kit

AH-150-1 MultiMax hutch to base attachment kit

Timber fixing kit

Reinforcement bracket and CT-HDWE-037 fixings

CH-9225 Rear bedding door latch and fixings

Instructions for MultiMax Assembly

MultiMax

Assembly Instructions

(if using power tools do

not over-tension)

Quantity

Page 1 MultiMax Assembly Instructions Thank you for buying a Calf-Tel MultiMax Hutch. We recommend that you: Check you have all the fixings and equipment you need Assemble the timber base Assemble the MultiMax hutch Attach the hutch to the base. Attach reinforcing brackets and bedding door latches.
Page 2 Assemble the timber base The base is built upside down and then flipped over to give a level top surface for attaching the hutch. The longer, narrower pieces of timber at the front and back provide a gap to insert loader tines to move the completed hutch easily. a) To assemble the base you will need: ...
Page 3 You will need:  Left and right side panels, roof and back  Bag of hutch fixing components AH-151-1 b) Place the left and right sides of the MultiMax on the ground standing upright approx. 5 feet (1.5m) apart as shown.
Page 4 4. Attach the Hutch to the Base Drill through tabs here a) You will need the bag of hutch to base components AH-150-1 b) Put the hutch on the base with the front opening at the front of the base nearest the L brackets. c) Fasten the hutch to the base around the edge using washers and screws starting at the back corner and going across the back first.