Section 4: Product Setup & Operation; Burner Test; Operation; Adjustment - Prism Hardscapes Moderno Series Installation, Operation & Maintenance Manual

SECTION 4 PRODUCT SETUP & OPERATION

4.1 BURNER TEST

For manual light units, you will need a fireplace lighter. Do not use a match or cigarette lighter as they
are much shorter and will light the fuel too close to the burner which may result in serious injury. If you
have a propane unit, turn the valve at the top of the propane tank counter clockwise until it can go no
further, this is the fully open position for the tank and will deliver gas up to the key valve.
Ignite your fireplace lighter and hold the tip close to the burner. Insert fire table key and turn it to the
ON position to start gas flow to the burner. If your burner does not light within 5 seconds, turn key to
the OFF position and wait 10 seconds before trying again. If the burner still does not light, call your local
gas technician to determine if there is a problem. Make sure the key valve is properly closed every time
you leave your fire feature unattended and remove key.
Once burner lights, immediately remove your hand and allow burner to operate for a few minutes
before turning it off. You are now ready to place the fire media onto the burner pan. Slowly pour media
onto pan and spread evenly. Fire media should be sparsely spread out enough to cover pan. Only use
the recommended amount of media in your unit, overfilling may result in smaller flame and gas buildup
which may cause an explosion. Fresh air must be able to pass through the unit. Do not block or obstruct
any vents on lower and upper parts of the fire feature. These are designed to ensure proper combustion
and ensure no buildup of residual gases within the unit.
CAUTION: Open flames will ignite combustible materials such as clothing, fabric, hair, etc. which
may result in serious injury, property damage and/or death. Be cautious of the open flames while
burner is lit.

4.3 OPERATION

With your fireplace lighter ready and in position, insert key and turn to ON position to ignite burner. You
may adjust the flame slightly by turning the key slowly.
After use, turn key to OFF position and remove; keep key in a safe and secure location away from
children.

4.4 ADJUSTMENT

Allow the fire feature and media to cool down before moving or adjusting. This may take from ½ to 1
hour depending on the size of the fire feature. Any shifting of fire media should be done after the entire
unit has cooled.